Husqvarna 40-C80 80W Battery Charger Owner’s Manual

 Operator’s manual

40-C80 80W Battery Charger

Statement

This leaflet is used to add a new charger type of 40-C80.
PRODUCT OVERVIEW
(Fig. 1)

1. Charging LED
2. Connector
3. Battery charger 40-C80

Battery charger safety

WARNING: Read all safety warnings and all instructions in the Operator’s manual. Failure to obey the warnings and instructions may result in electrical shock, fire, and/or serious injury.
CAUTION: Do not use other battery chargers than the one supplied for your product. Only use QC80/40-C80 chargers when you charge BLi replacement batteries.

Operation

To connect the battery charger

1. Connect the battery charger to the voltage and frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet.

Note: The battery does not charge if the battery temperature is more than 50 °C/122 °F. If the temperature is more than 50 °C/122 °F, the battery charger makes the battery become cool.
To charge the battery
Note: Charge the battery if it is the first time that you use it. A new battery is only 30% charged.

1. Connect the battery to the battery charger. (Fig. 2)
2. Make sure that the green charging light on the battery charger comes on. That means that the battery is connected correctly to the battery charger. (Fig. 3)
3. When all LEDs on the battery come on, the battery is fully charged. (Fig. 4)
4. To disconnect the battery charger from the main socket, pull the plug. Do not pull the cable.
5. Disconnect the battery from the battery charger.

Note: Refer to the battery and battery charger manuals for more information.

Accessories

Approved battery chargers for the product

www.husqvarna.com 
Original instructions
536858101

2022-03-22