Whirlpool W11550670B Electric Gas Dryer User Guide

Whirlpool W11550670B Electric Gas Dryer User Guide

QUICK REFERENCE GUIDE WHIRLPOOL® ELECTRIC/GAS DRYER

WARNING:

FIRE OR EXPLOSION HAZARD

Failure to follow safety warnings exactly could result in serious injury, death, or property damage.
Do not store or use gasoline or other \ammable vapors and liquids in the vicinity of this or any other appliance.

• WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re department.
• Installation and service must be performed by a qualied installer, service agency, or the gas supplier.

WARNING

: Gas leaks cannot always be detected by smell. Gas suppliers recommend that you use a gas detector approved by UL or CSA. For more information, contact your gas supplier. If a gas leak is detected, follow the “What to do if you smell gas” instructions.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions, including the following:

• Read all instructions before using the dryer.
• Do not place items exposed to cooking oils in your dryer. Items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch fire.
• To reduce the risk of fire due to contaminated loads, the final part of a tumble dryer cycle occurs without heat (cool down period). Avoid stopping a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
• Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, drycleaning solvents, or other flammable or explosive substances as they give off vapors that could ignite or
  explode.
• Do not allow children to play on or in the dryer. Close supervision of children is necessary when the dryer is used near children.
• Before the dryer is removed from service or discarded, remove the door to the drying compartment.
• Do not reach into the dryer if the drum is moving.
• Do not install or store the dryer where it will be exposed to the weather.
• Do not tamper with controls.
• Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published user-repair instructions that you understand and have the skills to carry out.
• Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.
• Do not use heat to dry articles containing foam rubber or similarly textured rubber-like materials.
• Clean lint screen before or after each load.
• Keep area around the exhaust opening and adjacent surrounding areas free from the accumulation of lint, dust, and dirt.
• The interior of the dryer and exhaust vent should be cleaned periodically by qualified service personnel.
• See Installation Instructions for grounding instructions.

CONTROL PANEL AND FEATURES

1. POWER
   Touch to turn on/off or to stop/cancel a cycle
2. WHAT TO DRY/HOW TO DRY
   First select a cycle from the “What to dry” and then select the “How to dry” to get the best combination cycle available for the type of items you are going to dry. See “Cycle Guide” for cycle details.
3. START/PAUSE
   Touch and hold; cycle will start after countdown. Touch START/PAUSE during a cycle to pause it. Touch again to resume.
   MODIFIERS (Not all cycles and options are available on all models.)
   NOTE: Dryer remembers the last completed cycle and cycle settings. The next time you turn dryer on, it will be set to run the\ last cycle Temp
   Touch to modify the cycle’s available temperatures (Air Only, Low, Medium, Medium High, High). Follow garment label instructions for best results. Once a cycle has started, the temperature can be changed within the first 5-8 minutes. Dryness Touch to modify the cycle’s available dryness levels on the sensor cycles (Less, Normal, More).
   NOTE: Dryness is for use with Automatic Cycles only. Wrinkle Shield™ Option Touch to turn on/off and on with steam (select models). Wrinkle Shield™ option adds up to 150 minutes of periodic tumbling and
   heat to help reduce wrinkling. Wrinkle Shield™ option with steam will add a short steam cycle after 60 minutes to help smooth wrinkles.
4. CYCLE OPTIONS (Not all cycles and options are available on all models.)
   Use to select available modifiers for your dryer. Remote Enable Touch each time you want to remotely control via the Whirlpool® app. Follow the instructions in the “GET THE WHIRLPOOL® APP AND GET CONNECTED” section below for more details. NOTE: Once Remote Enable has been selected, certain interactions with the dryer will cause it to cancel Remote Enable. Example: Opening the door.

Damp Dry Signal

Touch Damp Dry Signal or touch and hold Drum Light (depending on the model) for at least 3 seconds to turn the
Damp Dry Signal on or off. You will get a sound and display notification as “Items are damp. You can pause and reposition or best results”.

Drum Light

Touch to turn the drum light on/off.

Steam Options

Touch to add Steam and/or Reduce Static to selected cycle. Steam option adds steam to the end of cycle to help smooth wrinkle. Reduce Static will automatically tumble and introduce a small amount of moisture to the load to help reduce static. For best results with Reduce Static, avoid small load sizes.

Steam Refresh (steam models only)

This cycle is best for reducing wrinkles from dry items. Cycle time will increase, depending on number of items. This is an independent cycle that cannot be combined with any other cycle.

More Time/Less Time Timed Dry Adjust

Touch More Time or Less Time with the TIMED DRY/QUICK cycle to increase or decrease the length of the cycle time.

EcoBoostTM Option

The EcoBoostTM option will default on only for the REGULAR/
NORMAL cycle and is only available on that cycle. This option allows you to increase your energy savings by using a slightly lower heat level. The EcoBoostTM option will increase drying
times by approximately 40 minutes, which will be reflected on the LCD Display. If optimal time is desired, touch EcoBoostTM to turn off this option.

Cycle Signal

Use this option to turn the signal indicating the end of a drying cycle to Low, Medium, High, or Off.
NOTE: Press/hold Cycle Signal to select the volume

More Options

Touch to select your “Favorite cycle” (Only available for models with Wi-Fi capability).

Favorite cycle: You may create “custom” cycles in the app and store one frequently-used or favorite cycle on the machine.

LCD DISPLAY

When you select a cycle, its default settings will display and the Estimated Time Remaining (for Automatic Cycles) will vary depending on “What to dry” and “How to dry” selections, or actual time remaining for TIMED DRY cycles (for Manual Cycles) will be displayed.

CYCLE PHASE LABELS

Sensing

Displays during Sensor cycles to indicate that the moisture sensor on the dryer is operating. It will not be displayed during Timed/Quick Dry cycles or options such as Wrinkle Shield™ option.

Drying

Dryer is in the main dry phase of the automatic cycle.

Steaming

Steam option selected and Steam phase running.

Cool Down

The dryer has finished drying with heat and is now tumbling the load without heat to cool it down.

 

Static Reduce

Reduce Static phase is running.

End

Display message will show “Drying is complete” and will time- out after 5 minutes. This will indicate that the selected cycle has ended and the load may be removed from the dryer. If Wrinkle Shield™ option has been selected, the dryer may continue to tumble the load, even if “End” is displayed.

Check Vent

The Check Vent alert is a feature available for Automatic cycles only. This alert will show the status of airflow through the dryer and the dryer vent system for the dryer’s life. During the sensing phase at the beginning of the cycle if it detects a blocked vent or low pressure it will display “Check vent. Clean lint screen or vent for better performance.”
REMEMBER: The dryer will continue to operate even when check vent notification is displayed, but poor airflow can impact dry times and overall performance.
Display message can be cleared by pressing any key with the exception of Power which will cancel the cycle.

GET THE WHIRLPOOL® APP AND GET CONNECTED

With your mobile device download the Whirlpool® app. You can get subscription and connectivity instructions, terms of use, and privacy policy at www.whirlpool.com/connect or in
Canada www.whirlpool.ca/connect.

 Once installed, launch the app and you will be guided through the steps to subscribe and create your user account to connect to your appliance. If you have any problems or questions, call Whirlpool® Connected Appliances at 1-866-333-4591. (Only available for models with Wi-Fi capability).
When unit is first powered on, it will prompt to select language before you see message to Download APP or press any other key to setup Wi-Fi later.

USING YOUR DRYER

If you unintentionally select wrong language during digital un-boxing and/or you want to get back to Factory settings then perform Factory Reset.

FACTORY RESET

Press/hold both Temp and Wrinkle Shield™ keys until display count-down has completed. Unit will power back on with “Select Language” display message.
NOTE: Government energy certifications for this model were based on the Regular + Normal Cycle, Highest temperature setting, Normal Dryness Level, EcoBoost™On. The as-shipped defaults were the same as the Government Energy Certification Settings except the default Temperature Setting of Medium was adjusted to the Highest temperature setting.
Cycles that are available for post-sale download may use more energy than the Normal cycle, upon which the energy use rating of this dryer is based.
*NOTE: See “Cycle Guide” for more information about cycles, settings, and options. Not all cycles, settings, and options are available with all models. Read all your Manuals for more information on your unit.

CYCLE GUIDE

Your dryer has a unique user interface to help you select the best cycle you need for your load. The “What to dry” “How to dry” layout guides you to the optimal cycle in two easy steps:

1. First determine what items are in the load that you are trying to Use that to guide your “What to dry” selection.
2. Then determine how you want the dryer to dry them by selecting the appropriate “How to dry” Modifiers are preset for the items being dried, but can be changed if desired.

To get the most energy savings and enhanced fabric care from your dryer, use the Automatic cycles. These cycles measure the drying air temperature and moisture levels to turn the dryer off once the load reaches the selected dryness level. Dryer performance and results may vary with service voltage less than rated voltage (Electric, 240 V; Gas, 120 V).

*Extended high-heat drying cycle intended to help sanitize items such as sheets and towels. This cycle is not recommended for all fabrics. For best results, this cycle should be run to completion to ensure sanitization and do not interrupt cycle.

*Extended high-heat drying cycle intended to help sanitize items such as sheets and towels. This cycle is not recommended for all fabrics. For best results, this cycle should be run to completion to ensure sanitization and do not interrupt cycle.

Models 7120, 8120, 8127

NOTE: These clothes dryer’s Government energy certifications were based on the Regular + Normal Cycle, Maximum Drying Temperature Setting, Normal Dryness Level, EcoBoostTM  On. The as – shipped defaults of EcoBoostTM  On, Wrinkle ShieldTM  option off, Remote Enable off, were used.

Models 5100 & 6120

NOTE: These clothes dryer’s Government energy certifications were based on the Regular + Timed Dry Cycle and Maximum Drying Temperature Setting. The as – shipped defaults of EcoBoostTM On, Wrinkle ShieldTM option off, Remote Enable off, Normal Dryness level, were used.

DRYER ICONS

ASSISTANCE OR SERVICE AND ADDITIONAL INFORMATION

 

 

Read More About This Manual & Download PDF: