Samsung SWA-W500 Soundbar User Manual

SAMSUNG SWA-W500 USER MANUAL

Safety Information

Thank you for purchasing this product (SWA-W500).

  • The slots and openings in the cabinet and in the back or bottom are provided for necessary ventilation. To ensure reliable operation of this apparatus, and to protect it from overheating, these slots and openings must never be blocked or covered.
    • Do not place this apparatus in a confined space, such as a bookcase, or built-in cabinet, unless proper ventilation is provided.
    • Do not place this apparatus near or over a radiator or heat register, or where it is exposed to direct sunlight.
    • Do not place vessels (vases etc.) containing water on this apparatus. A water spill can cause a fire or electric shock.
  • Do not expose this apparatus to rain or place it near water (near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc.). If this apparatus accidentally gets wet, unplug it and contact an authorized dealer immediately.
  • Do not overload wall outlets, extension cords or adaptors beyond their capacity, since this can result in fire or electric shock.
  • Route power-supply cords so that they are not likely to be walked on or pinched by items placed on or against them. Pay particular attention to cords at the plug end, at wall outlets, and the point where they exit from the apparatus.
  • To protect this apparatus from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the set due to lightning and power line surges.
  • Before connecting the AC power cord to the DC adaptor outlet, make sure the voltage designation of the DC adaptor corresponds to the local electrical supply.
  • Never insert anything metallic into the open parts of this apparatus. Doing so may create a danger of electric shock.
  • To avoid electric shock, never touch the inside of this apparatus. Only a qualified technician should open this apparatus.
  • Make sure to plug the power cord in until it is firmly seated. When unplugging the power cord from a wall outlet, always pull on the power cord’s plug. Never unplug by pulling on the power cord. Do not touch the power cord with wet hands.
  • If this apparatus does not operate normally – in particular, if there are any unusual sounds or smells coming from it – unplug it immediately and contact an authorized dealer or service centre.
  • Maintenance of Cabinet.
    • Before connecting other components to this product, be sure to turn them off.
  • Be sure to pull the power plug out of the outlet if the product is to remain unused or if you are leaving the house for an extended period of time (especially when children, elderly, or disabled people will be left alone in the house).
    • Accumulated dust can cause an electric shock, an electric leakage, or a fire by causing the power cord to generate sparks and heat or the insulation to deteriorate.
  • Contact an authorized service centre for information if you intend to install your product in a location with heavy dust, high or low temperatures, high humidity, chemical substances, or where it will operate 24 hours a day such as in an airport, a train station, etc. Failing to do so may cause serious damage to your product.
  • Use only a properly grounded plug and wall outlet.
    • An improper ground may cause electric shock or equipment damage. (Class l Equipment only.)
  • To turn this apparatus off completely, you must disconnect it from the wall outlet. Consequently, the wall outlet and power plug must be readily accessible at all times.
  • Do not allow children to hang on the product.
  • Store the accessories (battery, etc.) in a location safely out of the reach of children.
  • Do not install the product in an unstable location such as a shaky self, a slanted floor, or a location exposed to vibration.
  • Do not drop or strike the product. If the product is damaged, disconnect the power cord and contact a service centre.
  • To clean this apparatus, unplug the power cord from the wall outlet, and then wipe the product using a soft, dry cloth. Do not use any chemicals such as wax, benzene, alcohol, thinners, insecticide, air fresheners, lubricants, or detergent. These chemicals can damage the appearance of the product or erase the printing on the product.
  • Do not expose this apparatus to dripping or splashing. Do not put objects filled with liquids, such as vases, on the apparatus.
  • Do not plug multiple electric devices into the same wall socket. Overloading a socket can cause it to overheat, resulting in a fire.

WARNING :

  • TO PREVENT THE SPREAD OF FIRE, KEEP CANDLES AND OTHER ITEMS WITH OPEN FLAMES AWAY FROM THIS PRODUCT AT ALL TIMES.
  • To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.

Wiring the Main Power Supply Plug (UK Only)

IMPORTANT NOTICE

The mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of the fuse is indicated on the pin face of the plug and if it requires replacing, a fuse approved to BS1362 of the same rating must be used. Never use the plug with the fuse cover removed. If the cover is detachable and a replacement is required, it must be of the same colour as the fuse fitted in the plug. Replacement covers are available from your dealer. If the fitted plug is not suitable for the power points in your house or the cable is not long enough to reach a power point, you should obtain a suitable safety approved extension lead or consult your dealer for assistance. However, if there is no alternative to cutting off the plug, remove the fuse and then safely dispose of the plug. Do not connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord. Never attempt to insert bare wires directly into a mains socket. A plug and fuse must be used at all times.

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:– BLUE = NEUTRAL BROWN = LIVE As these colours may not correspond to the coloured markings identifying the terminals in your plug, proceed as follows:– The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or coloured BROWN or RED.

WARNING : DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER E OR BY THE EARTH SYMBOL , OR COLOURED GREEN OR GREEN AND YELLOW.

Precautions

  1. Ensure that the AC or DC power supply in your house complies with the power requirements listed on the identification sticker located on the rear of your product. Install your product horizontally, on a suitable base (furniture), with enough space around it for ventilation (7~10 cm). Make sure the ventilation slots are not covered. Do not place the unit on amplifiers or other equipment which may become hot. This unit is designed for continuous use. To fully turn off the unit, disconnect the AC plug from the wall outlet.
  2. Do not expose the unit to direct sunlight or other heat sources. This could lead to overheating and cause the unit to malfunction.
  3. Unplug the Power cord from the AC wall socket if the unit malfunctions. Your product is not intended for industrial use. It is for personal use only. Condensation may occur if your product has been stored in cold temperatures. If transporting the unit during the winter, wait approximately 2 hours until the unit has reached room temperature before using it.
  4. If the electricity supplied to your home is rated at 240V AC, use a suitable plug adapter to connect this unit to your electrical outlets.

Important Safety Instructions

Read these operating instructions carefully before using the unit. Follow all the safety instructions listed below. Keep these operating instructions handy for future reference.

  1. Read these instructions.
  2. Keep these instructions.
  3. Heed all warnings.
  4. Follow all instructions.
  5. Do not use this apparatus near water.
  6. Clean only with a dry cloth.
  7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
  8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including AV receivers) that produce heat.
  9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
  10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where it exits the apparatus.
  11. Only use attachments/accessories specified by the manufacturer.
  12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
  13. Unplug this apparatus during lightning storms or when you intend to leave it unused for long periods of time.
  14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

Checking the Components

  • Design and specifications are subject to change without prior notice.
  • For more information about the power supply and power consumption, refer to the label attached to the product. (Label: Rear of the Main Unit)

Specifications

Weight 4.7 Kg
Dimensions (W x H x D) 250.2 x 273.0 x 250.2 mm
Operating Temperature Range +5°C to +35°C
Operating Humidity Range 10% ~ 75%
Woofer Drive Size / Impedence 165.1 mm / 3 ohm
Wireless device output power SRD max transmitter power 25mW at 5.725GHz – 5.825GHz

NOTES

  • Samsung Electronics Co., Ltd reserves the right to change the specifications without notice.
  • Weight and dimensions are approximate.

Open Source Licence Notice

  • To send inquiries and requests for questions regarding open sources, contact Samsung via Email ().

Important Note About Service

  • An administration fee may be charged if either
    (a) an engineer is called out at your request and there is no defect with the product (i.e. where the user manual has not been read).
    (b) you bring the unit to a repair centre and there is no defect with the product (i.e. where the user manual has not been read).
  • You will be informed of the administration fee amount before a technician visits.

Connecting the SWA-W500 to a Soundbar

1. Check the standby status after plugging into an electrical outlet

Plug the Wireless Subwoofer power cord into an electrical outlet and into the Wireless Subwoofer to turn on the Wireless Subwoofer. The LINK LED indicator (blue LED) on the Wireless Subwoofer blinks. If the LED does not blink, refer to page 9.

  • The main unit is heavy. Be careful not to pinch your fingers when pressing the ID SET button or connecting the power cord to the rear of the unit.
  • The upper part of the subwoofer is prone to scratches. Handle it carefully.
  • Do not press on or strike the Speaker Unit on the bottom of the body. You can deform or damage the speaker.

2. Turn off the Soundbar

Turn off the Soundbar by pressing the (Power) button on the remote control.

  • The images of the Soundbar shown on this page may differ from your Soundbar, depending on the model.

3. Configure “ID SET” using the Soundbar’s remote control

Press the Up button on the remote control for 5 seconds or press the ID SET button located at the bottom of the Soundbar.

  • Until pairing is complete, the Multicolour LED on the Soundbar changes as “Red → Green → Blue” in turn. When the connection is complete, “Cyan” blinks 3 times in the LED indicator of the Soundbar.
  • Steps for “ID SET” may vary by Soundbar model. Please read manual for your Soundbar. If the manual does not provide “ID SET” instructions, follow steps described in the image below.

4. Check if the LINK LED is solid blue (connection complete)

The LINK LED indicator stops blinking and glows a solid blue when a connection is established between the Soundbar and the Wireless Subwoofer.

NOTE

  • If the SWA-W500 does not connect, take the necessary steps shown below according to the LED Indicator’s status.

Compatible Models

HW-S60T HW-S66T HW-S61T HW-S67T
  • The model list is subject to change without further notice.
  • To check compatability with Soundbars to be released after 2020, please refer to the FULL MANUAL of the Soundbar (http://samsung.com/support).

Hereby, Samsung, declares that this equipment is in compliance with Directive 2014/53/EU.

The full text of the EU declaration of conformity is available at the following internet address: http://www.samsung.com go to Support > Search Product Support and enter the model name. This equipment may be operated in all EU countries.

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)

(Applicable in countries with separate collection systems)

This marking on the product, accessories or literature indicates that the product and its electronic accessories (e.g. charger, headset, USB cable) should not be disposed of with other household waste at the end of their working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate these items from other types of waste and recycle them responsibly to promote the sustainable reuse of material resources.

Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take these items for environmentally safe recycling.

Business users should contact their supplier and check the terms and conditions of the purchase contract. This product and its electronic accessories should not be mixed with other commercial wastes for disposal.

For information on Samsung’s environmental commitments and product specific regulatory obligations e.g. REACH, WEEE, Batteries, visit: http://www.samsung.com/uk/aboutsamsung/samsungelectronics/corporatecitizenship/data_corner.html

© 2020 Samsung Electronics Co., Ltd. All rights reserved.

Contact SAMSUNG WORLD WIDE

If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care Centre.