Canon Zoemini C Instant Camera Printer User Manual

Canon Zoemini C Instant Camera Printer User Manual

SAFETY INFORMATION

READ BEFORE USE

Please read the following instructions and safety precautions before using the device. For regulatory and additional safety information, refer to the Regulation and Warranty Information sheet included in your package contents.RMN: PP3001   Regulatory Model Identification Number is assigned for regulatory identification purpose.

Warning

  • Keep away from children and Improper use of this product may cause suffocation or accident.
  • Stop using the device immediately if it emits smoke or a strange smell, or otherwise behaves
  • Do not look at the sun or bright lights through the viewfinder or the Blindness or vision problems could result.
  • Do not fire the flash near the It may hurt the eyes.
  • A strap wound around a child’s neck may result in If your product uses a power cord, mistakenly winding the cord around a child’s neck may result in asphyxiation.
  • Turn the device off in places where camera use is The electromagnetic waves emitted by the camera may interfere with the operation of electronic instruments and other devices. Exercise adequate caution when using the product in places where use of electronic devices is restricted, such as inside airplanes and medical facilities.

CAUTION

  • When operating in extreme weather, the device might not Let the printer temperature adjust to the recommended operating temperature of 15º to 32ºC, before attempting to print again.
  • When charging, please charge the device at the recommended temperature of 15º to 32ºC.
  • Use a soft dry cloth to clean the Do not clean with a damp cloth or volatile liquids such as paint thinner.
  • Keep the top cover closed to avoid dust and other particles from entering the inside of the
  • If the device is not functioning properly, please contact the dealer you purchased this product from or Canon Service & Support at https://www.canon-europe.com/support
  • Never expose the battery to high temperatures, direct heat, or dispose by
  • Electromagnetic interference or electrostatic discharge may cause the device to malfunction or the memory to be lost or Should this occur, use a pin, or similar item to press the [RESET] button at the bottom of the device.

OVERVIEW

SUPPLIED ITEMS

  1. Instant Camera Printer
  2. Quick Start Guide
  3. Regulation and Warranty Information sheet
  4. USB Cable
  5. CANON ZINK™ Photo Paper (10 sheets)
  6. Wrist Strap

PRODUCT FEATURES

  1. Camera Lens
  2. Selfie Mirror
  3. Print Output Slot
  4. Strap Hole
  5. Flash
  6. Status LED
  7. Power Button
  8. Shutter Button
  9. Viewfinder
  10. Speaker
  11. Printer Cover
  12. Aspect Ratio Button
  13. Reprint Button
  14. MicroUSB Port
  15. Charging Status LED
  16. MicroSD Card
  17. Slot (up to 256GB)
  18. Reset Button * To reset the device, press with a pin

SETUP

CHARGING

The device has a built-in battery. Please fully charge the device via the USB cable provided before using.

  1. Insert the smaller end of the supplied USB cable into the device and other end into a chargeable USB adapter.
  2. The charging LED light will turn red to indicate charging.
  3. Once fully charged, the charging LED will turn green. Operating time may vary depending on the battery status, operational status and environment conditions.

NOTE

About USB Cable

HANDLE THE USB CABLE WITH CARE WHILE CHARGING

  • Do not place any heavy objects on top of the
  • Do not place the USB cable near
  • Do not scratch damage, twist or pull hard on the
  • Do not plug or unplug the cable with wet
  • Avoid too high/too low temperature or humid
  • Please unplug the USB cable from power source after
  • Please use the supplied USB cable for

LOAD PAPER

  1. Remove the cover by sliding it forward in the direction of the arrow.
  2. Open a single pouch of photo paper (10 sheets + blue SMART SHEET™).
  3. Place all 10 photo paper sheets and the one SMART SHEET™ into the photo paper compartment Stack the photo paper on top of the blue SMART SHEET™, making sure the blue barcode and the photo paper logos are facing.
  4. Place the top cover back onto the device. It should click into place when closed properly. The blue SMART SHEET™ will be sent through the device automatically before the first

 

EXTERNAL MEMORY


An external MicroSD card (up to 256 GB) is needed for saving captured photos. Only FAT16, FAT32 and exFAT format are supported.

PREPARING A MEMORY CARD

Use the following memory cards (sold separately)

  • MicroSD memory cards *1
  • MicroSDHC memory cards *1 *2
  • MicroSDXC memory cards *1 *2 *1 Cards conforming to SD standards. However, not all memory cards have been verified to work with the camera. *2 UHS-I memory cards are also supported.

INSTALL AND REMOVE THE MicroSD CARD

  • Insert the Micro SD card into the slot at the bottom of the You will feel a slight click when the card is fully inserted .
  • Push on the top of the card to release Gently pull to fully remove the card from the device.
  • If there is an error on reading /writing to the Micro SD card, remove the Micro SD card and restart the
  • Connect the device to a computer by USB Double-click the external drive image when it appears on the computer to view and save the photos.

NOTE

MAINTAINING THE DEVICE

  • Use and keep the device in the recommended environment of 15º to 32º C and 40-55% relative

WHEN USING PHOTO PAPER

  • Only load 10 ZINK™ photo paper sheets and 1 SMART SHEET™. Do not load more as it can result in paper jams or printing
  • If there is a paper jam, simply turn the printer OFF and ON to automatically clear the paper Don’t try to pull the paper out.
  • While the device is printing, don’t pull or tug on the photo
  • Handle photo paper carefully to avoid damage or
  • Keep the photo paper clean when If photo paper is dirty or damaged, it may result in a paper jam or print error.
  • Don’t open a new pouch of photo paper until you are ready to load it into your
  • Don’t expose photo paper to direct sunlight or
  • Don’t leave your photo paper in an area where the temperature or humidity is out of the suggested conditions indicated on the It may reduce the quality of the printed photo.

ABOUT THE SMART SHEET™

  • Each pouch of photo paper contains 10 sheets of photo paper and 1 blue SMART SHEET™.
  • Load the SMART SHEET™ and photo paper from within the same pouch for optimal print quality. Each SMART SHEET™ is specifically tuned for the pouch of paper it is contained
  • The SMART SHEET™ will be sent through the device automatically before the first print to clean the printer and optimize print quality for that specific paper pouch (10 sheets).
  • Keep the SMART SHEET™ and only discard after you have printed all 10 sheets of photo paper in the If print quality is not as expected, you can reuse the SMART SHEET™ if the paper is still from the same pouch. Simply slide the SMART SHEET™ with its barcode-side down underneath the remaining photo paper.
  • Using a SMART SHEET™ from another pouch may result in reduced print

OPERATION

POWER ON/OFF

  1. Press and hold the Power button until the LED indicator light turns on.
  2. When the LED indicator turns to a stead   y white , the device is ready to use.
  3. Press and hold the Power button to turn off the device.

AUTO POWER OFF

  • When the device is idle for about 5 minutes, it will automatically power The user can resume the device by pressing the Power button again.

TAKING A PHOTO

  1. Hold the device, confirm the desired composition of the image.
  2. Press the Shutter button  to take a photo
    The camera will automatically trigger the flash if it is necessary for the lighting conditions
    Use the reflective plate besides the lens as a self-portrait mirror for selfie

VIEWFINDER

Compose an image with the frame mark in the viewfinder


2 X 3 Frame Mark for normal shooting at 1m – ∞

2 X 2 Frame Mark for normal shooting at 1m – ∞

ASPECT RATIO

The user can choose between two aspect ratios, 2×3 and 2×2 with the Aspect ratio button  .

Aspect ratio can be changed at any time before taking a photo.

When the aspect ratio is 2×2, the blank area of the photo paper is different. It is based on how the device is being held.

 



PRINTING AND REPRINT

PRINTING A PHOTO

  • The photo will be printed out immediately after taking the
  • The device can hold up to 3 images at a time to

REPRINT A PHOTO

When you have captured a photo and it is printed out, if you want to duplicate the same photo or distribute several pieces of the same photos in a party, you can just simply press the Reprint button   to reprint the last printed photo.

LED INDICATOR

Status Operation/Situation LED Indictior
Power On

 

Press and hold the Power Button

 

 

Standby After the device is powered on

 

Power Off Press and hold the Power Button

 

Smart Sheet Error When the device detects wrong SMART SHEET™ is inserted, or other SMART SHEET™ error
Processing  SHEET SMART When the device is printing out SMART SHEET™

 

 

No Paper

 

When the device has no paper, the device will not allow for taking a photo

 

Paper Jam/ Cover Open When there is a paper jam or the printer cover is opened

 

Printing Preparing for printing

 

Printing Photo

 

When the device is printing a photo

 

MS Mode (Mass Storage Mode) Device is Connected to a computer
MicroSD Card Error

 

Cannot write data into MicroSD Card

 

 

Temperature Too High

 

When the device temperature is too high

 

Temperature Too Low

 

When the device temperature is too low

 

Printer Head Cooling Checking the  printer head  temperature and letting it cool down before printing
Low Battery                            When battery level is down to 20%
Very Low Battery

 

When battery level is very low

 

Status LED Indictior Actions
MicroSD Card Error

 

Check if the MicroSD card is inserted properly

 

 

Check if the MicroSD card is full

 

Check if the MicroSD card is corrupted

 

Check if the MicroSD card is compatibl

Paper Feeding Failed

 

Open the paper compartment cover to check if Canon ZINK™ photo paper is inserted

 

Paper Jam Power off and on the device, the photo paper will be fed out automatically

 

No Paper

 

Reload Canon ZINK™ photo paper into the device

 

Printer cover is not closed properly Close the printer cover properly

 

Overheat

 

Wait until the device temperature returns to normal, the device will resume working again
Device does not Work

 

N/A Make sure the battery level is not too low. If it is, recharge the device
Take a Photo

 

N/A Make sure print queue buffer is available

Make sure device has Canon ZINK™ photo paper

 

SPECIFICATIONS

Printing Technology                   ZINK™

Printing Resolution                314 x 500 dpi (dots per inch)

Printing Speed                       Approximately 50 seconds – Motor starts and stops, at room temperature 25º C

Photo Aspect Ratio                2″ x 2″ or 2″ x 3″

Compatible Paper                   Canon ZINK™ Photo Paper : ZP-2030-20 (20 sheets) ZP-2030-50 (50 sheets) 2″ x 3″ /Peel-and-Stick Back

Paper Capacity                      Up to 10 sheets of ZINK™ photo paper + 1 SMART SHEET™ Photo Resolution        5MP

Focal Length                          24 mm

Aperture                                f / 2.4

Focusing Range                      50cm – ∞

Sensitivity                             Auto (ISO 100 – 1600)

Flash                                     YES (Auto)

 

Flash Range                           0.5m – 1.0m

Memory Card                         MicroSD Card, up to 256GB

Power Source                         Built-in Rechargeable Li-Polymer Battery 700mAh, 7.4V Charging Speed Approximately 90 minutes (Full Charge)

Power Adapter                       Output Current : 1.6A (min) Voltage : 5V

Environmental Parameters      – Recommended Printing Operating, Charging, and

Storage Temperature : 15º to 32º C Recommended Printing Operating, Charging, and Storage Humidity : 40-55% RH Operating Temperature : 5º to 40º C Operating Humidity : < 70% RH

Automatic Power-off              5 minutes

Dimension                              121mm (W) x 78.3mm (H) x 23.7mm (D)

Weight                                 170 g

Compatible OS                       Windows 7 / 8 / 8.1 / 10

(for Computer)                       Mac OSX 10.10 – 10.14

Connection for Charging         USB 2.0 (Micro USB) and Data Transfer