Honeywell Digital Room Thermostat User Guide
Honeywell Digital Room Thermostat User Guide
User Guide
- Room temperature
- Set temperature, inquiry
- Set temperature, adjustment
- Switch ON/OFF (frost protection enabled)
Operating indicators
- Heating demand indicator
- Frost protection
Frost protection is not available in cooling operation - Fault indicator
- Low battery indicator
- Heat/cool changeover
Energy Saving ECO feature
- Pressing the green ECO button gives a timed period at a different,
predefined temperature (18°C) - To set the ECO energy savings time period
- Display shows countdown of ECO time remaining
- Pressing
or will now allow the ECO temperature to be changed - To exit ECO mode, press ECO button again
Installation
= M3.5
= No 6
Installer Mode
- To enter Installer Mode
- To select a parameter
- Display
- Parameter flowchart
- To change a parameter
- To exit Installer Mode
Parameters
Description | Parameter | Range of values | Default |
Minimum ON/OFF time | Ot | 1,2,3,4,5 m | 1 m |
Cycle rate | Cr | {3,6,9,12} | 6 |
Proportional band width | Pb | 1.5 … 3.0 K | 1.5K |
Temperature measurement offset | tO | 3 … 3 K | 0 K |
Upper setpoint limit | uL | 21 … 35 °C | 35°C |
Lower setpoint limit | LL | 5 … 21 °C | 5°C |
ECO temperature / Temperatura ECO | ES | 5 … 35 °C | 18 °C |
Heat/cool changeover | HC | 0, 1 0 = Disable |
0
|
1 = Enable | |||
Off setpoint adjust | OS | — (= Off), 5…16°C | 5°C |
Electric heat | EH | 0 (<3A) / 1 (3A – 8A)><3A) / 1 (3A – 8A) | 0 (<3A) |
Reset parameters | FS | 0 / 1 | 1 (factory) |
For assistance with this product please visit livewell.honeywellhome.com
bk-electronic GmbH
Hardhofweg 40
74821 Mosbach
Germany
Country of origin: UK
Was this manual helpful?
Thank you for your feedback!