SEALEY HVD16C CORDED HIGH-VELOCITY DRUM FAN 16 230V User Manual

SEALEY HVD16C CORDED HIGH-VELOCITY DRUM FAN 16 230V

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

• Refer to instructions
• Indoor Use Only
• Do not cover

SAFETY

1. ELECTRICAL SAFETY
   WARNING! It is the user’s responsibility to check the following:
   Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and all electrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electrical products. You may obtain an RCD by contacting your local Sealey stockist.
   If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable Appliance Test) tested.
   ELECTRICAL SAFETY INFORMATION: it is important that the following information is read and understood.
   1. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
   2. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
2. GENERAL SAFETY
   • Disconnect the fan from the mains power when not in use and before servicing or performing any maintenance.
   • Use the fan in dry areas only. DO NOT use in wet or areas with high condensation such as showers, pools etc.
     WARNING! If the fan falls into water or any other liquid, immediately switch off and disconnect from the power supply. DO NOT touch the fan until the power supply has been disconnected.
   • Always disconnect the fan from power supply if moving from one location to another and ensure fan is stood on a level surface.
   • The fan air flow is powerful. Before use ensure that there is nothing nearby that will be damaged or displaced by the stream of air.
   • Keep the fan clean and maintained in good condition.
   • Ensure battery is inserted with polarity correct.
   • Only use designated battery packs.
   • DO NOT operate the fan where there are explosive or flammable gases, fumes or other hazardous substances.
   • DO NOT stand the fan on the power cable.
   • DO NOT operate fan without grill in place.
   • DO NOT handle power adaptor with wet hands.
   • DO NOT insert any objects through the fan guard.
   • DO NOT pull the power adaptor plug from the mains socket by the lead.
   • DO NOT get the power adaptor wet, or use in wet, damp conditions (for indoor use only).
   • DO NOT cover the fan when in use.
   • DO NOT immerse the fan in water or any other liquid.
   • DO NOT allow children to operate the fan.
   • DO NOT stand the fan where it may be knocked over or off a surface, or where the lead may cause a person to trip.
   • DO NOT use the fan outdoors.
   • DO NOT modify speed control or attempt to fit any additional external speed control device to the fan.
   • DO NOT try to take the power adaptor plug apart.
   • DO NOT allow supply terminals to be short-circuited.
   • DO NOT use power adaptor for any other product.
   • DO NOT place fan or batteries near fire or heat,
   • When not in use place the fan in original box, or otherwise cover to protect from dust and store in a safe, dry, childproof location.
   • If fan is to be stored or unused for a long period remove the battery.
     WARNING! DO NOT use any other type of power adaptor with this product than the supplied power adaptor. Failure to observe this warning could result in injury and or fire and will invalidate the warranty.
     WARNING! Remove battery pack from appliance while being charged.

This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

INTRODUCTION

Part of the SV20 Series offering a one-battery-fits-all solution, keeping costs down without compromising on performance. High velocity continuous variable speed drum fan which is mains or cordless power meaning increased versatility in positioning cooling where it is most required. Lightweight, portable and robust unit fitted with rubber feet for stability. Features a handle plus 360° tilting stand allowing control of airflow to exactly where it is needed. Carefully balanced and fully guarded aluminium blades provide quiet and safe operation and is suitable for use in industrial, commercial, agricultural, automotive workshop, showroom and home applications. To run cordless requires compatible 20V battery and mains charger, sold separately. CP20VBP4 (4Ah), CP20VBP6 (6Ah), CP20VMC (Mains Charger).

SPECIFICATION

• Model No:……………………………………………………….HVD16C
• Current:………………………………………………………………….1.2A
• Fan diameter:……………………………………………………………16”
• Maximum Airflow:………………………………………………1650cfm
• Power:……………………………………………………………………24W
• Speed Range:…………………………………………….580-1470rpm
• Speeds:………………………………….Continuous Variable Speed
• Supply:…………………………………………………………..20V 220V

ASSEMBLY

1. Assemble fan as shown in fig.1. To tighten fan at an angle use thumb wheels (fig.1.1, fig.1.3).
2. Connect battery to unit (fig.2.A). See safety section for guidance. Note supply terminals (fig.2.B). Polarity is marked on the body.
3. When using the mains supply, see safety section for guidance. Insert power supply cable to port on appliance (fig.2.D).

OPERATION

WARNING! Ensure that you read, understand and apply safety instructions in Section 1 before using fan.

1. Check that the speed control is set to OFF and then plug into power supply or fit battery (fig.2) and switch the power on.
2. To adjust the fan speed use the control knob on the Power Adaptor (fig.3)
3. Adjust the direction of the air flow by moving from side to side and tilting the fan up or down as required (fig.1).
4. Turn the speed control switch to OFF and disconnect the fan from mains power or remove battery pack after use (fig.2, fig.3).

MAINTENANCE

WARNING! Ensure that the fan is disconnected from the mains power supply before attempting any of the following:

1. Use a soft, damp cloth to clean the fan.
   DO NOT immerse the fan in water and never allow water to drip onto the motor housing. DO NOT use solvents, petroleum, paint thinner or other chemicals to clean the fan.
2. To clean the fan blade, undo the cross headed screws around the circumference, remove the grille and clean the blade with a slightly damp cloth. Replace the grille as required and refit the cross headed screws.
3. Should the motor, switch or the power lead require service or maintenance contact your local Sealey stockist.

ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 www.sealey.co.uk