Maytag Front Load Washer Owner’s Manual
MAYTAG Front Load Washer
DETAILED PLANNING DIMENSION
MAYTAG® FRONT LOAD WASHER WITH EXTRA POWER AND 24 HOUR FRESH
HOLD® OPTION – 5 cu ft
ELECTRICAL REQUIREMENTS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance’s Owner’s Manual, before installing and operating this appliance.
Electrical Requirements | |
MHW8630HC MHW8630HW | 5.0 cu ft DOE (US)/5.8 cu ft IEC (CAN) |
Minimum Circuit Amperage Rating | 15 A |
Maximum Ampere Draw | 10.36 A |
Operating Voltage | 120 V AC only |
Operating Frequency | 60 Hz |
PRODUCT DIMENSIONS
MHW8630HC MHW8630HW | 5.0 cu ft DOE (US)/5.8 cu ft IEC (CAN) | |||
Unit of Measurement | in (minimum) | mm (minimum) | in (maximum) | mm (maximum) |
Height (with feet) (A) | 385∕8 | 981 | 40 | 1016 |
Product Width (B) | 27 | 686 | – | – |
IMPORTANT: Dimensional specifications are provided for planning purposes only.
MHW8630HC MHW8630HW | 5.0 cu ft DOE (US)/5.8 cu ft IEC (CAN) | |||
Unit of Measurement | in (minimum) | mm (minimum) | in (maximum) | mm (maximum) |
Door Width (C) | 221∕4 | 565 | – | – |
Product Depth (D) | 3215∕16 | 837 | – | – |
Product Depth with Door Open (E) | 5215∕16 | 1345 | – | – |
Door Height (F) | 221∕8 | 562 | – | – |
Height to Bottom of Door (G) | 10 | 254 | – | – |
MHW8630HC MHW8630HW | 5.0 cu ft DOE (US)/5.8 cu ft IEC (CAN) | |||
Unit of Measurement | in (minimum) | mm (minimum) | in (maximum) | mm (maximum) |
Position of Power Cord (H) | 355∕16 | 897 | – | – |
Power Cord Length | 72 | 1829 | – | – |
Position of Water Inlet Valves (I) | 355∕16 | 897 | – | – |
Position of Drain Hose (J) | 8 | 203 | – | – |
Drain Hose Length | 52 | 1321 | – | – |
Diameter of Drain Hose | 1 | 26 | – | – |
All Dimensions show recommended spacing allowed, except for closet door ventilation openings which are minimum required.
This washer has been tested for installation with spacing of 0″ (0 mm) clearance on the sides. Consider allowing more space for ease of installation and servicing, and spacing for companion appliances and clearances for walls, doors, and floor moldings. Add spacing of 1″ (25 mm) on all sides of washer to reduce noise transfer. If a closet door or louvered door is installed, top and bottom air openings in door are required.
*For additional details (or information) specific to your model, refer to your Quick Start Guide.
CUSTOM UNDER COUNTER INSTALLATION
RECESSED AREA OR CLOSET INSTALLATION
NOTE: All 27″ wide washers should have 19″ clearance, while all 29″ wide washers should have 22″ clearance