Motorola PMLN6759 Impress Temple Tranducer Headset User Guide
motorola PMLN6759 Impress Temple Tranducer Headset User Guide
FOREWORD
RF Energy Exposure and Product Safety Guide for Portable Two-Way Radios Attention!
The IMPRES Temple Transducer Headset, when attached to the radio, is restricted to occupational use only to satisfy FCC/ ICNIRP RF energy exposure requirements. Before using this product, read the RF Energy Exposure and Product Safety Guide that ships with the radio which contains instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulation.
ACOUSTIC SAFETY
Exposure to loud noises from any source for extended periods of time may temporarily or permanently affect your hearing. The louder the volume, the less time is required before your hearing could be affected. Hearing damage from loud noise is sometimes undetectable at first and can have a cumulative effect. To protect your hearing
- Use the lowest volume necessary to do your
- Turn up the volume only if you are in noisy
- Turn down the volume before connecting headset or
- Limit the amount of time you use headsets or earpieces at high
- When using the radio without a headset or earpiece, do not place the speaker directly against your ear.
- If you experience hearing discomfort, ringing in your ears, or speeches that are muffled, you should stop listening to your radio through your headset or earpiece, and have your hearing checked by your doctor.
DESCRIPTION
The PMLN6759 IMPRES Temple Transducer Headset features high performance bone vibration speakers for clear audio reception in noisy environments. It uses a discrete, lightweight and streamlined “ear loop” that provides users with bone conduction technology. Unlike conventional headsets, the Temple Transducer allows the user’s ears to be uncovered and completely free to hear surrounding environmental sounds, while still using the two-way portable radio.
An in-line push-to-talk (PTT) button and microphone frees the user from holding the radio while communicating.
Figure 1: Attaching the Accessory Connector to the radio
Figure 2: Detaching the Accessory Connector from the radio.
OPERATION
- Wear the Temple Transducer Headset as shown in Figure 3.
- Be sure to position the bone vibration speakers on your temples.
Figure 3: Wearing Position of the headset. - Clip the in-line PTT switch in a convenient operating
- Turn the radio
- Connect the accessory connector to the radio as shown in Figure
- Turn the radio on, adjusting the audio volume to an appropriate level.
- When the headset is connected to the radio side connector, the radio’s speaker is muted and the audio is only heard from the Temple Transducer
- Press and hold down the in-line PTT button and begin speaking in order to
- Your radio will return to receiving mode when you release the in-line PTT button after you finish speaking.
- Turn the radio off before removing the accessory connector from the radio as shown in Figure 2.
Note: You may actually feel the Temple Transducer speakers shake or vibrate when the receive volume is too high. For more comfortable use, set the receive volume to an appropriate level.
SERVICE
The PMLN6759 IMPRES Temple Transducer Headset is not serviceable. It is covered under the Motorola Solutions one year limited warranty. Order a replacement headset as necessary.