Honeywell Flanged Linear Valves Installation Guide

This is a legacy product document supported by Resideo. It is no longer manufactured

FLANGED LINEAR VALVES

INSTALLATION INSTRUCTIONS

DANGER OF INJURY! Media under high pressure can cause significant injury. Before removing actuator or valve parts, the system pressure must be lowered to ambient pressure. The valves are to be installed by skilled personnel and in strict accordance with the installation instructions and local regulations. Honeywell assumes no responsibility for damages or injuries resulting from non-compliance with installation instructions or standard good practice when mounting, operating, or maintaining the valves, even if not explicitly mentioned in the installation instructions. Proper use: These valves are only for use in closed cold, warm, and hot water circuits and (depending upon the given valve) for closed steam applications. They are designed for a medium temperature range of from 2 to (depending upon the given valve) 120 or 220 °C, as well as for a max. the pressure of 6 to (depending upon the given valve) 40 bar. They are to be operated with the appropriate Honeywell actuators, only. Please refer to the specification data. The installation of a strainer is strongly recommended.

® U.S. Registered Trademark Copyright © 2017 Honeywell Inc.  All Rights Reserved

Manufactured for and on behalf of the Environmental & Energy Solutions Division of Honeywell Technologies Sàrl, Rolle, Z.A. La Pièce 16, Switzerland by its Authorized Representative:

Home and Building Technologies

Honeywell GmbH Böblinger Strasse 17 71101 Schönaich, Germany Phone: (49) 7031 63701 Fax: (49) 7031 637493 http://ecc.emea.honeywell.com Subject to change without notice. MU1B-0096GE51 R1017 / 32333959-001