Whirlpool WED5010LW White Moisture Sensing Electric Dryer User Guide
Whirlpool WED5010LW White Moisture Sensing Electric Dryer
DETAILED PLANNING DIMENSIONS
Electrical Requirements | ||
Fuel Type |
Electric |
Gas |
Minimum Circuit Amperage Rating | 30A |
15A |
Maximum AMP Draw | 26A |
6A |
Operating Voltage | 120/240 V – AC only |
120 V – AC only |
Current Canada Rating | 24A | |
Operating Frequency | 60 Hz |
Product Dimensions | |||
in |
mm | ||
A | Height (With leveling legs not extended) | 40 1/2 |
1028 |
B | Width | 29 |
737 |
C | Top Height (with min. feet) | 36 7/8 |
937 |
D | Depth | 28 8/3 |
722 |
E | Top Height (With leveling legs fully extended) | 38 1/2 |
978 |
F | Height (With leveling legs fully extended) | 42 1/8 |
1069 |
G | Depth with Door Open | 4111∕16 |
1059 |
Product Dimensions | |||
in |
mm | ||
H | Strain Relief from Side (electric) | 15 3/4 |
400 |
I | Strain Relief Height (electric) (With leveling legs not extended) | 28 1/8 |
714 |
J | Exhaust Duct from Side | 14 7/16 |
366 |
K | Power Cord from Side (gas) | 14 3/4 |
375 |
L | Power Cord Height (gas) | 32 3/8 |
822 |
M | Gas Connection (With leveling legs not extended) | 1 11/16 |
43 |
N | Gas Connection from Side | 9 3/16 |
234 |
O | Strain Relief Height (electric) (With leveling legs fully extended) | 29 3/4 |
755 |
P | Exhaust Duct Height (With leveling legs fully extended) | 6 11/16 |
170 |
Q | Power Cord Height (gas) | 34 |
863 |
R | Gas Connection (With leveling legs fully extended) | 3 5/16 |
84 |
S | Exhaust Duct Height (With leveling legs not extended) | 5 1/16 |
128 |
Gas Power Cord Length | 60 |
1525 |
Spacing for recessed area or closet installation
The dimensions shown are for the recommended spacing allowed.
- Additional spacing should be considered for ease of installation and servicing.
- Additional clearances might be required for wall, door, and floor moldings.
- Additional spacing of 1″ (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilations openings are acceptable.
- Companion appliance spacing should also be considered.
Was this manual helpful?
Thank you for your feedback!