Honeywell T3R Programmable Thermostat Relay Pairing Instructions
WIRELESS BINDING GUIDE
T3R Programmable Thermostat
On the Wireless Relay Box
- Press the
pinhole button for 3 sec. The LED should flash ORANGE once. - Press and hold the
buttons for 3 sec. The
LED should blink ORANGE continuously. On the Programmable Thermostat - Hold the Thermostat -1m away from the Relay Box and press the MENU and — buttons together for 3 sec to enter the binding menu.
If 14A and 0 is flashing follow steps 4-8 If 14A and 1 is flashing follow steps 9-12 - Press the
should start flashing. - Press the + button. 1 should start flashing. A small 1 will appear on the left side. If a 0 appears repeat.
- Press the
button until SAVE is displayed. The LED on the Relay Box should change to GREEN. - Press the
button to return to the Home Screen. - Cycle the temperature all the way up and then all the way down to test that the Relay Box is switching on and off (this might take a few minutes).
If 14A and 1 is flashing follow these steps - Press the + button until 14C:0 is displayed.
- Press the
should start flashing. - Press the + button. 1 should start flashing.
- Press the
button to SAVE and follow steps 3-8.
Pittway Sarl, Z.A. La Pièce 4,
1180 Rolle, Switzerland
Country of origin : UK
© 2021 Resideo Technologies, Inc. All rights reserved.
The Honeywell Home trademark is used under license from Honeywell International Inc.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
t3-rebind-ug-en0h8596uk07
Was this manual helpful?
Thank you for your feedback!