Yamaha NS-AW190 Speaker Owner’s Manual

NS-AW190 / NS-AW390
INDOOR / OUTDOOR SPEAKER SYSTEM
OWNER’S MANUAL
THIS PACKAGE INTERNATIONAL LEFT BLANK

Read these precautions carefully before setting up your NS-AW190/NS-AW390 speakers.

  • When installing these speakers outdoors, try to minimize their exposure to rain and snow by mounting the speaker in corners or under eaves.
  • Since these speakers are to be wall-mounted, it is essential that they are firmly secured. Be sure to consult a reliable source about the best type of mounting solution for your particular wall’s construction. Secure installation is the purchaser’s responsibility.
  • Do not attach the speakers to thin plywood or soft wall surface materials as the screws may tear-free, causing the speakers to fall and be damaged, or result in personal injury.
  • Do not fasten the speakers to walls with nails, adhesives, or other unsafe hardware. Long-term use and vibrations may cause them to pull free.
  • Do not place the speakers where they are likely to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance.
  • Never touch the woofer or tweeter units with your hands or expose them to excessive physical shock. If they are dented or bent, the sound will be distorted.
  • Lower the power amplifier/receiver volume control before changing input sources. Never change input sources (for example, FM to CD) at high listening levels. Always turn the receiver/amplifier unit off when installing or removing input cables.
  • If you notice distortion, reduce the volume control on your power amplifier/receiver to a lower setting. Never allow your power amplifier to be driven into “clipping.”
  • Do not attempt to clean the speakers with chemical solvents as this might damage the finish. To clean, wipe the speakers with a dry, soft cloth.
  • Secure placement or installation is the owner’s responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers.

UNPACKING

After unpacking. please inspect the contents to confirm all the following items are included:

MOUNTING THE SPEAKERS

To wall/ceiling mount the speakers, use the supplied mounting bracket (see below).

OUTDOOR NOTE: The supplied mounting brackets allow the speakers to be mounted in corners or under eaves to minimize their exposure to rain or snow.

  1. Use the bracket as a template to mark the locations of the keyhole slots on the mounting area.
  2. Next. use appropriate hardware (not included) to securely fasten the bracket to the walking.
  3. Position the speaker in the bracket and secure the speaker by using the two large bracket screws included (see above).

Tips for mounting:

The speakers also have threaded insert nuts (matched for 1/4* bolts) located on the back of the units so that some types of optional brackets available in the market can be used.
* CAUTION:
Be sure to consult a reliable source for the best type of fasteners for your particular wall! ceiling construction.
Secure installation is the purchaser’s responsibility.
When using speaker brackets to mount the speaker on a wall, please use a safety wire between the speaker and the bracket to prevent the speaker from falling.
How to use the safety wire:

  1. Hook one side of the safety wire to the bracket’s hole.
  2. Fix the other side of the safety wire together with the supplied screw.

 

CONNECTIONS TO YOUR AMPLIFIER

Before making connections, make sure that the amplifier is switched off.

CONNECTIONS

  • Connect the input terminals at the rear of the speakers to the speaker output terminals of the amplifier (or receiver) with speaker cables (not included).
  • One side of the speaker cable is (+) and the other side is (-). Connect the (+) terminals on the amplifier (or receiver) and speakers using the (+) side. Connect the (-) terminals on both components using the (-) side of the
  • Connect each speaker making sure not to reverse the polarity (+. -). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass.

How to Connect

  1. Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.
  2. Press down and hold the terminals tab.
  3. Insert the bare wire into the terminal hole.
  4. Release your finger from the tab to allow it to lock securely on the bare wire end.
  5. Test the firmness of the connection by pulling Ightly on the cord at the terminal.

Note
Do not let the bare speaker wires touch each other as this could damage the speaker or amplifier (or both).

SETTING UP THE SPEAKERS

INDOOR PLACEMENT
You can use these speakers as front or surround speakers.

  • Front speakers placement should be separated by a distance of 6-10ft. If they are placed to dose together, there will be a reduction in the stereo effect. Conversely, if placed too far apart, the so-called “middle-omission” effect will occur and the vocal center fill will be lost. Speaker height should be at least at ear level.
  • Center channel speakers should be centered and placed above or below the TV.
  • Surround speakers should ideally be placed behind the listening area, at least as far apart as the front speakers and up to 2 additional feet apart per side. Ideally, the height of the speaker should be a minimum of ear level or preferably somewhat higher.


OUTDOOR PLACEMENT

Your speaker system has water-resistant enclosures that protect the speakers from the elements when mounted outdoors. These speakers are designed with a wide dispersion pattern, which means you will get good sound quality over a large listening area (100 ft2 to approximately 400 ft2). Please note if the listening area is too large, and the speakers are positioned too far apart, the “middle-omission” effect (lack of sound in an area between the speakers) will occur and/or “hot spots” (loud sound near the speaker) will develop.
Try to place the speakers between 6-10′ apart for good stereo listening. It is suggested for larger areas (over 400 ft2 to about 600 ft2) that two pairs of speakers be used. See Below:
Note

  • 1 pair of speakers should be used for every 200-400 ft.
  • We recommend that you install this speaker vertically, as it is designed to ensure a wide listening area in this orientation.

SPECIFICATION

<NS-AW190>

Type 2-Way Acoustic Suspension
Speaker Woofer 5″ P.P. mica filled cone woofer with rubber surround Tweeter 1/2″ PEI Dome
Frequency Range 65 Hz — 40 kHz
Impedance 6 ohms
Nominal Input 35 W
Maximum Input 120 W
Sensitivity 85 dB/2.83 V/m
Crossover Frequency 4 kHz
Dimension (H x W x D) 8.9- x 5.9′ x 5.6″ (225 x 149 x 142 mm)
Weight 3.09 lbs (1.4 kg)
Magnetic Shielding NO

<NS-AW390>

Type 2-Way Acoustic Suspension
Speaker Woofer 6.5′ P.P. mica filed cone woofer with rubber surround Tweeter 1″ PEI Dome
Frequency Range 55 Hz-40 kHz
Impedance 6 ohms
Nominal Input 40 W
Maximum Input 130 W
Sensitivity 87 dB/2.83 V/m
Crossover Frequency 3 kHz
Dimension (H x W x D) 11.1″x 7.3- x 7.1″ (281 x 186 x 180 mm)
Weight 4.85 lbs (2.2 kg)
Magnetic Shielding

No

*Specifications subject to change without notice due to Product Improvements.

YAMAHA CORPORATION OF AMERICA
6600 ORANGETHORPE AVE., BUENA PARK, CA 90620

Yamaha loudspeakers are designed and manufactured to provide a high level of trouble-free performance. Yamaha Corporation of America is proud of the experienced craftsmanship that gees IMO each and every Yamaha loudspeaker. Yamaha sells its loudspeakers only through a network 01 high quality, specialty authorized dealers and is pleased to offer the following Limited Warranty. whits apply only to products purchased from our authorized dealers. We suggest that you read the United Warranty thoroughly, and invite you to contact your authorized Yamaha dealer or the Yamaha Corporation of America service department you have any questions.

LIMITED WARRANTY

INDOOR / OUTDOOR SPEAKER SYSTEM

Duration of Warranty:
This Speaker System is covered by this warranty for a period of two (2) years beginning from the date of first consumer purchase.
What Is Covered and What Is Not Covered?
This warranty covers all defects in materials or workmanship in this product, but DOES NOT COVER the following:

  1. Damage, deterioration, or malfunction resulting from:|
    a, Accident, negligence, misuse, abuse, improper installation or operation, or failure to follow instructions contained in your Owner’s manual.
    b, Any shipment of the product. (Claims must be presented to the carrier.)
    c, Repair or attempted repair by anyone other than Yamaha or an authorized Yamaha Preferred Customer Service Center,
  2. Any unit which has been altered or on which the serial number has been defaced, modified, or removed.
  3. Normal wear and any periodic maintenance.
  4. Any unit which has not been purchased from an authorized YAMAHA dealer in the U.S.A. If you are uncertain as to whether a dealer has been authorized by YAMAHA. please contact YAMAHA’s Service Department.
  5. Any und used for industrial or commercial purposes,

Who may enforce the warranty:
This warranty is enforceable only by the original purchaser.
What we will pay for and what you must pay for:
YAMAHA will repair or replace units covered by this warranty, without charge to the consumer for labor or materials. YOU ARE RESPONSIBLE FOR ANY INSTALLATION OR REMOVAL CHARGES AND FOR ANY INITIAL SHIPPING CHARGES. the Components must be shipped for warranty service. However, we will pay the return shopping charges to any destination within the U.S.A. if the repairs are covered by the warranty.
How you can get Warranty Service:

  1. YAMAHA Speaker Systems requiring service must be delivered to any authorized YAMAHA Service Center within the fifty states of the U.S.A. the District of Columbia or Puerto Rico. Warranty service is not available at any other location or outside the U.S.A.
  2. Units shipped for service should be packed securely and must be accompanied by a detailed explanation of the problem(s) requiring service And a Bill of Sale as proof of Warranty coverage.
  3. Warranty registration is not required for Warranty coverage,

Limitation of Implied Warranties:
ANY IMPLIED WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE LENGTH OF THIS WARRANTY.
Exclusion of Damages
YAMAHA’S LIABILITY, FOR ANY DEFECTIVE PRODUCT. IS LIMITED TO REPAIR OR REPLACEMENT OF THE PRODUCT, AT OUR OPTION. YAMAHA SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES OR DAMAGES OF ANY OTHER KIND OF CHARACTER BECAUSE OF PRODUCT DEFECTS.
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS AND/OR DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SOME ABOVE LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
Should you have any questions about service received or if you need assistance in locating an authorized Yamaha Service Center, please contact:

CUSTOMER SERVICE
YAMAHA CORPORATION OF OF AMERICA
6600 ORANGE7HORPE AVE.
BUENA PARK. CA 90620.1373
http://usa.yamaha.com
Phone: (800)292-2982

YAMAHA products are backed by a nationwide network of high-quality YAMAHA authorized Service Centers, providing prompt, courteous, and professional service.

THIS PRODUCT INTERNATIONAL LEFT BLANK

YAMAHA CORPORATION OF AMERICA
6600 ORANGETHORPE AVENUE
BUENA PARK, CA 90620
http://usa.yannaha.com
Phone: (800) 292-2982
Printed in Taiwan
P/N 430068
PEV 03.09