Honeywell evohome HR9 User Guide
evohome
HR9 1
32325381 -001 B 
1. Press and hold
2. Press the green tick
3. Press ADD ZONE.
4. Type a name for the new zone and press the green tick
5. Press RADIATOR VALVE.
6. If you want to control the zone temperature with the evohome Controller (which needs to be located in that zone) press YES, otherwise press NO.
7. Press the binding button
8. The
9. Successful binding is confirmed by
10. You should receive a SUCCESS message on the evohome Controller (if not go back and re-bind).
11. Either press the green tick
You must repeat these steps for each radiator controller.
Manufactured for and on behalf of the Environmental & Energy Solutions Division of Resideo Technologies Sàrl, E&ES, Z.A., La Pièce 16, 1180 Rolle, Switzerland by its Authorised Representative Honeywell Home Inc.
Conforms to protection requirements of the following directives: EMC: 2014/30/EU, LVD: 2014/35/EU, R.E.D.: 2014/53/EU
Hereby, Honeywell Home declares that this HR91 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following Internet address: getconnected.honeywell.com
Receiver Category 2
WEEE Directive 2012/19/EU
At the end of the product life dispose of the packaging and product in a corresponding recycling centre. Do not dispose of the unit with the usual domestic refuse. Do not burn the product.
Ademco 1 GmbH
Hardhofweg 40
74821 Mosbach
Phone: +49 1801 466 388
[email protected]
homecomfort.resideo.com
@2020 Resideo Technologies, Inc.
All rights reserved The Honeywell Home trademark is used under license from Honeywell International Inc. This product is manufactured by Resideo Technologies, Inc and its affiliates.
