Hoover HGO 300 Hydro Robot Vacuum Instruction Manual

H-GO 300 HYDRO

PRINTED IN P.R.C.
Part No：48031524

A quick guide to the first use of your Robot

Remove the Robot, charging station, main power adaptor, and remote control from the packaging.
Place the charging station against a wall. Check for obstacles in the range
indicated.
Put the batteries into the remote control.
  Switch on the Robot with the on/off switch on the bottom.
Plugin the main power adaptor and connect it to the charging station. Charge your Robot for at least 8 hours before using it for the first time.
To start cleaning, just press the AUTO cleaning mode on the Robot or the start/ pause button on the remote control.
Selecting the AUTO cleaning mode, Robot automatically calculates the best path to fully clean your room.
For optimum performance, empty the dust container after every use.
For optimum performance, clean the filter after every use.
Remove the mopping cloth from the bottom part of the water tank. Open the water tank’s rubber cap, fill it up with water and close it again.
Align the water tank with the robot’s bottom part and push it into its correct position until you hear a click indicating it is properly fixed.
After mopping, open the rubber cap and pour the remaining water out of the tank.

A quick guide to Remote Control

Always refer to the user manual for more information