Honeywell HF561 Fixed Wide-angle 2D Image Scanner User Guide

Honeywell HF561 Fixed Wide-angle 2D Image Scanner

Please power off the computer before connecting the scanner, and then power on the computer after the scanner is fully connected.

Power Adapter (if included)

Note: Please refer to the user guide for the information on the cleaning equipment.

USB Connection

RS232 Connection

Notes: The separated blue and yellow wires can connect to an external beeper or LED indicator if needed. Please find the detailed information in the User Guide.

Mounting Information

M3 screws shall be used and the maximum length is 5.5mm/0.22in. Maximum torque is 4.5kg/lbf and the maximum drawing force is 750N.

Reading Skills

• To acquire a good reading effect, the scanner center shall be aligned to the barcode, but the alignment can be made at any direction to facilitate reading.
• When the scanner aligns to the barcode, the scanner shall be close to the barcode if the barcode is too small; if the barcode is large, the scanner shall be slightly away from the barcode, so that the scanner can more easily read the barcode.
• If the reflectance on the surface of barcode is high (e.g., film coating), you may need to incline the scanner at an angle, so that the scanner can more easily read the barcode.

Factory Default
USB Version Interface Setting
USB version supports USB HID and USB virtual serial port. The user may scan the following barcode to switch.

1. USB keyboard interface
2. USB keyboard interface

Indicator Setting

1. Indicator ON
2. Indicator OFF

Enter/ Tab Setting

1. Add Enter
2. Add Tab
3. Cancel Enter/ Tab

Technical Support
For contact information on technical support, after-sales service and maintenance, please visit https://sensing.honeywell.com/contact-support-form
User Documentation
For a localized version of this document and to download the “User Guide”, please visit https://sensing.honeywell.com/
Valid Warranty
For warranty information, please visit www.honeywellaidc.com, and click Resources > Warranty
Patent
For patent information, please visit www.hsmpats.com

Declaration

• Honeywell reserves the rights to revise the specifications and other information in this document without prior notice. Regardless of whether there are any revisions, the reader is advised to refer to the final explanation by Honeywell. The information in this document does not represent Honeywell’s pledge.
• Honeywell is not accountable for any technical or editorial mistakes or omissions in this document, and is not responsible for accidents or indirect harm caused by equipment, demonstration or use of this material. Honeywell disclaims all liability for the results of the choice and/ or use of this hardware/ software for specific purposes.
• Proprietary information contained in this document is protected by copyright, all rights reserved. Without prior written consent from Honeywell, no part of this document can be copied or reproduced in any form, or translated to other languages.