D-Link DWM-222 4G LTE USB Adapter Installation Guide
D-Link® DWM-222 4G LTE USB Adapter Quick Installation Guide
PRODUCT SETUP
INSERT SIM CARD BEFORE USING
Insert the SIM card by following the icon direction shown in the diagram on the left or use the SIM adapter if required.
INSERT SIM CARD BEFORE USING
Slide the cover on the back of the device and lift off. Then insert the SIM card by following the icon direction.
SOFTWARE INSTALLATION
Insert the DWM-222 into a USB port on your computer. The set-up wizard should start automatically. Make sure that your SIM card is in the slot. Follow the steps within the wizard to complete the set-up of DWM-222.
TROUBLESHOOTING
- WHERE CAN I FIND MORE INFORMATION ABOUT HOW TO USE THIS DEVICE?
A comprehensive User Manual is available for the DWM-222. Open the D-Link Mobile Connection manager and click: Help. - WHY AM I UNABLE TO CONNECT TO A MOBILE SERVICE NETWORK?
The DWM-222 requires a SIM card registered with a compatible service network. For information about the services that your SIM card provides access to, please contact your mobile service provider. - WHY IS THE SOFTWARE ASKING FOR A PIN NUMBER?
For security, some SIM cards have a PIN number enabled. If the SIM was used in a previous device, the PIN will be the same as it was before. If you did not set a PIN, please contact your mobile service provider.
LED INDICATION
Red (blinking): No SIM card/ Error
Green (blinking): Connected to LTE network
Blue (blinking): Connected to 3G network
TECHNICAL SUPPORT
dlink.com/support
Spectrum and maximum power: GSM900 33 dBm;GSM1800 30 dBm;WCDMA I 23 dBm; WCDMA VIII 23 dBm;
LTE Band1 23 dBm; LTE Band3 23 dBm; LTE Band7 23dBm; LTE Band20 23 dBm
Caution: risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions
RF Exposure Information (SAR)
This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. Specific Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. SAR limits are 1.6 Watts per kilogram (over a volume containing a mass of 1 gram of tissue) in countries that follow the United States FCC limit and 2.0 W/kg (averaged over 10 grams of tissue) in countries that follow the Council of the European Union limit. Tests for SAR are conducted using standard operating positions with the device transmitting at its highest certified power level in all tested frequency bands. To reduce exposure to RF energy, use a hands-free accessory or other similar option to keep this device away from your head and body. Carry this device at least 5 mm away from your body to ensure exposure levels remain at or below the as-tested levels. Choose the belt clips, holsters, or other similar body-worn accessories which do not contain metallic components to support operation in this manner. Cases with metal parts may change the RF performance of the device, including its compliance with RF exposure guidelines, in a manner that has not been tested or certified, and use such accessories should be avoided.
Hereby, D-link declares that the radio equipment type DWM-222 is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: http://www.dlink.com/uk/en/support/cedoc
Maximum radio-frequency power transmitted in the frequency bands
Ver. 1.00(EU) _90x130 2020/11/09