VIKING PB-3-IP VoIP Emergency Phone Panic Button User Guide

VIKING PB-3-IP VoIP Emergency Phone Panic Button User Guide

Out-of-Box

Verify that you have received all of the parts listed

PB-3-IP Emergency Phone Panic Button

Hexkey 5/64

Gel-Filled Butt Connectors

Back Panel

Screw Set 8-32 Socket

Screw Flat Head Hex Drive 6-
32 x 1.25 Stainless steel

Wire Nut

Download the product manual

Scan the QR code to open and download the product manual
OR

  1. Go to www.vikingelectronics.com and enter PB-3-IP in the search box.
  2. Click PB-3-IP in the search results.
  3. Click Product Manual to open and download the PDF
Download and install the programming software
  1. Go to www.vikingelectronics.com and enter PB-3-IP in the search box.
  2. Click PB-3-IP in the search results.
  3. Scroll down the page to Downloads, click IP Programming Software.
  4. Install the programming software by saving or opening the file and then clicking on setup Viking IP Programming.exe.
  5. Follow the prompts on your screen to complete software installation.

Power Source

Select PoE Switch or PoE Injector that meets the following requirements:

  1. IEEE 802.3af / 802.3at / 802.3bt compliant.
  2. Capable of providing at least 4 Watts (class 1)
    Note: CAT5e (or higher) cable recommended.

Network Port Settings

  • Make sure the port is not in trunk mode
  • Make sure port is capable of 100mbps full duplex
  • Disable Spanning Tree Protocol (STP) or enable Portfast

Features Overview

Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a maximum insulation of 0.082 inches. Cut off stripped wire ends before terminating.

See the Product Manual for complete installation and programming instructions.
Questions? Call Viking Product Support: 715-386-8666

Due to the dynamic nature of the product design, the information  contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.