Dell R240 EMC PowerEdge User Guide
Dell EMC PowerEdge R240
Getting Started Guide
Before you begin
Setting up your system
- Connect the network cable and the optional I/O devices
- Connect the system to a power source
- Secure the power cable in the power cable retention clip
- Turn on the system
Technical specifications
The following specifications are only those required by law to ship with your system. For a complete and current listing of the specifications for your system,
see Dell.com/poweredgemanuals.
Power supply | Wattage at 100–240 V | Derated Wattage at 100–120 V – Low Line |
250 W Bronze AC 50/60 Hz, 4 A–2 A 450 W Platinum AC 50/60 Hz, 6.5 A–3.5 A |
250 W 450 W |
NA NA |
System battery: 3 V CR2032 lithium coin cell
Temperature: Maximum ambient temperature for continuous operation: 35°C/95°F
For information about Dell Fresh Air and supported expanded operating temperature range, see the Installation and Service Manual at Dell.com/poweredgemanuals.
Dell End User License Agreement
Before using your system, read the Dell Software License Agreement that shipped with your system. If you do not accept the terms of the agreement, see Dell.com/contactdell.
Save all software media that shipped with your system. These media are backup copies of the software installed on your system.
Regulatory model/type | E57S Series/E57S001 |
Quick Resource Locator
http://www.dell.com/QRL/Server/PER240
Scan to see how-to videos, documentation, and troubleshooting information.
© 2017 – 2019 Dell Inc. or its subsidiaries.
P/N K58VC Rev. A01
2019-12