Dell P4317Q Monitor Teardown Instructions
Disassembly Procedures:
Step |
Figure | Remark |
S1. remove the stand | Turn off the power, Unplug external cables from a product, remove stant from produce. | |
S2.Remove the Rear Cover. | Use Penknife to separate the deco and rear cove follow the arrows in sequence.
| |
Use a Philips-head screwdriver to remove 9 screws for unlocking Rear cover (No.1~9 screw size=M3x6; Torque=6±1kgf.cm) | ||
S3.Remove the Cables and keyboard | Use a Philips-head screwdriver to remove 17 screws for unlocking Main board and Power board (No.1~15 screw size=M3x6; Torque=4±1kgf.cm
No.16~17 screw size=M6x10; Torque=12±2kgf.cm) | |
Disconnect the pins. Use a Philips-head screwdriver to remove3 screws for unlocking Key board (No.1~3 screw size=Q2x2.3; Torque=0.9±0.4kgf.cm) | ||
S4.remove BKT | Use a Philips-head screwdriver to remove8 screws for remove BKT (No.1~8 screw size=M3x6; Torque=4±1kgf.cm) | |
S5.Remove thMain and PowBoard | Use a Philips-head screwdriver to remove 11 screws for Remove Mainboard and Inverter board (No.1~11 screw size=M3x6; Torque=6±1kgf.cm) Use a Philips-head screwdriver to remove6 screws for remove Power board (No.1~6 screw size=M3x6; Torque=6±1kgf.cm) Use a hex screwdriver to remove 4 screws for unlocking mainboard (No.1~4 Hex screw Torque= 4.5 ± 0.5kgf.cm) | |
S6.The Mainframe | Mainframe | |
S7.Remove panel. | Panel | |
S15.Remove capacitors | Remove electrolyte capacitors (red mark) from printed circuit boards | |
Take out the bulk cap. pin solder with soldering iron and absorber | ||
Lift the bulk cap. Up and away from the PCB |
Product material information
The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC.
Capacitors / condensers (containing PCB/PCT) | No used |
Mercury-containing components | No used |
Batteries | No used |
Printed circuit boards (with a surface greater than 10 square cm) | The product has printed circuit boards (with a surface greater than 10 square cm) |
Component contains toner, ink, and liquids | No used |
Plastic containing BFR | No used |
Component and waste contain asbestos | No used |
CRT | No used |
Component contain CFC, HCFC, HFC and HC | No used |
Gas discharge lamps | No used |
LCD display > 100 cm2 | Product has an LCD greater than 100 cm2 |
External electric cable | Product has external cables |
Component contains refractory ceramic fibers | No used |
Component contains radioactive substances | No used |
Electrolyte capacitors (height > 25mm, diameter > 25mm) | Product has electrolyte capacitors (height > 25mm, diameter > 25mm) |
Tools Required
List the type and size of the tools that would typically can be used to disassemble the product to a point where components and materials requiring selective treatment can be removed.
Tool Description:
– Phillip head Screwdriver
– Hex Screwdriver
– Penknife
– Soldering iron and absorber
P4317Q