LG GH-1660 Brass Monkey Upright Fridge and Freezer Instruction Manual

95L/138L
Upright fridge Manual
GH-1660 / GH-1662

SAFETY INSTRUCTIONS

WARNING:

  • Do not touch exposed cables with your bare hands when operating the appliance.
  • It is dangerous to touch the plug when your hand is wet.
    When using the refrigerator in a vehicle or boat, please make sure the power source is fused (ie has a fuse protecting the input power).
  • The installation of a wired DC power source should be handled by qualified personnel.
  • Make sure the input voltage is correct. Check technical data label
  • Do not place any electrical devices inside the refrigerator.
  • Please keep the fridge away from substances that can cause fire or an ignition source.
  • The appliance is not intended for use by young children or infirm persons unless they are adequately supervised by a responsible person to ensure that they can use the unit safely.
    Young children should be supervised to ensure that they do not play with the appliance.

PLEASE NOTE:

  • Your refrigerator requires good ventilation, especially around the back of the unit. Allow a gap of at least 200mm around the back and 100mm around the right.
  • Avoid humidity. Humidity inside the appliance can form frost and impair cooling. Therefore, defrost it before this happens. Never clean the appliance under running water or in dishwater.
  • Avoid placing your refrigerator near a heat source. This helps the refrigerator work more efficiently and keep the contents cool.
  • Place the refrigerator on a flat surface and away from any edges.
    When placing the refrigerator into the car, please use the belt to fasten it securely.

Please read these instructions and the safety section carefully before using your refrigerator.
Keep the instructions for future reference.

STRUCTURE OF REFRIGERATOR

(Because this manual is used for several models, some features and devices shown in the below figure may not contain in your refrigerator.)

(Drawer Type)

1.Refrigerator 4.lce tray
2.Shelves 5.Bottle rack
3.FruitandVegetableCrisper 6.Door

PRODUCT OVERVIEW

This refrigerator contains two compartments with different temperatures. The refrigerator section is used to refrigerate fruit, vegetable, eggs milk, and so on. The Freezer compartment is used for frozen food such as fish, meat, making ice, and so on.
This refrigerator adopts a fiat back panel design and has an elegant and graceful appearance.

PREPARATION BEFORE USING

Move

  • When moving the fridge, ensure it is tilted no more than 45 degrees and handle carefully.
    Do not use the door handle to lift the refrigerator.
    Do not invert, throw or drop the refrigerator.
  • Do not enlace the power cord or put it under furniture or any heavy Keep the power cord away from heat sources (such as the compressor).
  • Rated power supply: 12V/24V DC;
  • The power supply wire cannot be lengthened. Ensure the power cable is kept in good order. Do not enlace the wire or put it under furniture or other heavy items. It is advised that wire is NOT put near the compressor due to its high temperature at times.
  • If the power supply wire is damaged then please go back to the store of purchase to buy another.

Connecting Electricity
Placement

  • The refrigerator must be placed in a dry, cool, and ventilated place which is far from any heat source (such as a stove, or flue) and avoid direct sunlight.
  • Allow for space around the fridge for good air circulation (see the left figure):
    Top: 30cm Sides: 10cm Back: 20cm
  • Place the refrigerator on a floor that is flat and strong enough to support it when It’s fully loaded. If the floor is not flat enough, then adjust the feet (shown in figure I) to level the refrigerator. When not level it will cause vibration and noise.
  • If the refrigerator is placed on carpet, please place wooden boards under the refrigerator. Or the hot air produced by the compressor may discolor the carpet.

Warning: Remove the packaging plate under the bottom of the refrigerator before using.

OPERATING INSTRUCTIONS

Instructions for First Use

  • Unpack the fridge, remove the carton and place the refrigerator as per installation instructions.
  • Although the refrigerator has been cleaned before leaving the factory, we strongly recommend using a soft cloth dampened with warm water and a little neutral detergent to clean it again. After that wipe it with a dry soft cloth. (Warning: Electrical parts can be wiped by a dry cloth only)
  • Plugin the refrigerator and open the door. You will see the light in the refrigerator is on. Set the thermostat button at 3 to start the compressor After 30 minutes, open the freezer door. When you feel the temperature is obviously decreasing, the refrigerating system works properly. After the refrigerator works for a while, the thermostat will keep  the temperature in setting range automatically
  • For first time use, please put foods into the refrigerator after it cools down

FOOD STORAGE

Freezer (Below-18C)

  • Meat should be cut and wrapped tightly, and then evenly placed in the freezer
  • After buying frozen food, put it in the freezer whilst it is still in frozen
  • Do not put the fresh food and frozen food together
  • Do not put the fruit and vegetable in the freezer in order to avoid freeze-drying
  • Do not put a glass container or other container with a sealed lid that contains liquid into the freezer. Or there is a possibility of explosion as the liquid freezes and expands.

Refrigerator (0 °C-5°C)

  • Eggs, butter, milk, and bottled drinks can be put in the refrigerator.
    Fruit and vegetables should be put in the crisper for moisture retaining.
  • Hot food should be cooled down before its placed into the fridge or freezer, which could help to save power.
  • Food should be packed into zip-lock or vacuum-packed bags. Leaving space between these items to allow the circulation of cool air between them.

Quick-freezing

  • Food is frozen by a rapid process to retain the natural flavor and nutritional value
  • Quick-freezing is better than normal-freezingforMeatstorage
  • To start quick-freezing, you must set the temperature control at 6-7 and put the food in the middle of the freezer. After quick-freezing finishes set the temperature control  back to normal position

TEMPERATURE CONTROLLER

  1. Light
  2. Compensatory switch
  3. Thermostat

  • The temperature is controlled by a thermostat in the refrigerator. “l” is the least cold and “7” is the most cold. You can adjust it according to your requirement. A setting of 0 will force the refrigerator stopped.
  • Youcansetthetemperaturecontrolleratproperposition according to the ambient temperature and the number of contents loaded into the refrigerator.
  • Normally, we recommend setting it at”34considering the balance between keeping food fresh and saving energy.

Using in winter

  • In winter the indoor temperature may be below 10°C. If the refrigerator does not start or work properly, please turn on the compensatory switch shown in the picture on the left This will make the refrigerator work properly.
  • When the indoor temperature warms up or abnormal ice crystals appear on surfaces in the freezer please turn off the switch shown in the left figure.

DEFROSTING

After the refrigerator has been working for a period of time frost could develop on surfaces of the freezer, which reduces the refrigerating effect and increases power consumption.
Defrost directions

  1. Unplug the refrigerator and open the door, remove the contents (food/drink) from the refrigerator.
  2. Use a plastic defrosting shovel or plastic scraper to remove ice and frost (Or alternatively you can just leave the door open to allow the ice and frost to melt).
  3. Then use a cloth or towel to wipe away the water and ice.
  4. After that, place the food back in the refrigerator and plugin.

Note: – Do not use sharp metal tools to defrost which will damage the refrigerator.

THE FOLLOWING SITUATIONS ARE NORMAL

  • The flow of refrigerant through the evaporator may create boiling or gurgling sounds.
  • When it is raining outside and there is high humidity, moisture may form on the outside of the refrigerator or near the door gaskets.
    You can wipe any damp surfaces with a dry cloth.
  • The temperature on the back panel and doorframes may be high (particularly in summer) due to the heat emission of the condenser and defrost heater.
  • The temperature on external surfaces of the compressor may be high when the compressor is working.
  • The compressor may cause a high hum or pulsating sound when it is at starting or stopping step.
  • When the refrigerator is working some dew or frost may be found on the back panel inside the refrigerator.

SECURITY CERTIFICATE

Do not dispose of this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary.

Distributed by: 
TechBrands by
Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
Ph: 1300 738 555
Intl: +61 2 8832 3200
Fax: 1300 738 500
www.techbrands.com 
Made in China