Philips 2000 Series TAT2206 True Wireless Headphones User Manual
2000 Series
TAT 2206
Notice of compliance
The device complies with the FCC rules, Part 15. Operation is subject to the following two conditions
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
FCC rules
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the CC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation Thie equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications
However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna
- Increase the separation between equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/Ty technician for help
FCC Radiation Exposure Statement:
This equipment complies with CC radiation exposure limits set forth for an uncontrolled environment
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
Caution The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Canada:
This device contains license-exempt transmitter(s)/receiver(s) that comply with innovation, Science and Economic Development Canada’s license-exempt RSS(s) Operation is subject to the following two conditions. (1) this device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation of the device CAN ICES- 3(8)/0MB- 3(8)
IC Radiation Exposure Statement:
This equipment complies with Canadian radiation exposure limits set forth for uncontrolled environment¢
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter
Frequency range: 2402-2 408G4
Transmitter power: <10 8m (oily for EU)
FCC 2AR251A12206; IC 24589-1412206
* Full user manual in all languages available on:
www.philips.com/support
Philips and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V and are
used under license This product has been manufactured by and is sold under the responsibility of
MMD Hong Kong Holding Limited or one of its affiliates, and MMD Hong Kong Holding Limited is
the warrantor in relation to this product
Authorized Representative. UKCA Experts Ltd. Dept 302. 43 Owston Road Carcroft Doncaster,
DN6 8DA United Kingdom