Philips SPS6024BC-37 6-Outlet 2-USB Wall Tap with Surge Protection and Device Shelf User Manual

PHILIPS SPS6024BC-37 6-Outlet 2-USB WallTap with Surge Protection and DeviceShelf User Manual

Temporary Installation:

  1. Remove the mounting screw from the surge protector that is needed for permanent installation.
  2. Plug the surge protector into a standard grounding duplex wall receptacle, covering both outlets, by fully inserting the plug and ensure that there are no exposed conductors.
  3. The surge protector will now be providing power and surge protection.
  4. Make sure electronic equipment is turned off before plugging into the surge protector outlets. Do not use extension cords to connect equipment to the surge protector.
  5. Connected equipment can now be turned on.
  6. Hold the surge protector firmly against wall when removing plugs to prevent it from pulling loose.

Permanent Installation:

  1. Disconnect power to the receptacle at the service panel.
  2. Remove wallplate mounting screw from existing grounded duplex wall outlet and discard. DO NOT remove wallplate.
  3. Plug surge protector into wall outlet and secure with centre mounting screw provided.
  4. Restore power at service panel.
  5. The surge protector will now be providing power and surge protection.
  6. Make sure electric equipment is turned off before plugging into the surge protector outlets. Do not use extension cords to connect equipment to the surge protector.
  7. Connected equipment can now be turned on.

USB Charging

  • 2.4 Amp total output allows you to charge one tablet or two smartphones at full capacity at the same time. Recharge your device at a maximum speed of 2.4 Amps when connected to a single port.
  • The USB ports are used to charge portable electronic devices only. There is no data transfer capability.

CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, USE ONLY INDOORS.

UNIT SHOULD BE PLUGGED INTO AN INTERIOR GROUNDED PARALLEL DUPLEX RECEPTACLE. NOT FOR USE WITH GROUNDFAULT CIRCUIT-INTERRUPTER RECEPTACLES OR RECEPTACLES WITH INDICATOR LIGHTS OR CONTROL. TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS DEVICE WITH A RECEPTACLE IN WHICH THE SLOT OPENINGS DO NOT ALIGN WITH THE BLADES.

NOTE: Check the blue “PROTECTED” indicator light periodically. A glowing blue indicator light shows that surge protection is being provided. If the blue “PROTECTED” indicator light stops glowing, the surge protective components have expired — though power will still be supplied to the outlets, now unprotected. To ensure the protection of your electronics, the surge protector should be replaced.

Surge Protector — Limited-Lifetime Warranty

This surge protector is warranted to be free of defects in workmanship and/or materials for the life* of the surge protector. If such a defect should arise during the life of the surge protector, we will, at our option, either repair or replace the surge protector without charge. This warranty does not cover damage caused by lightning, accident, misuse or alterations to the surge protector.

* This surge protector, like all surge protectors, has a finite lifespan. Even under normal circumstances and in the absence of defects, the product’s life will expire when the surge protector’s component capacity has been exceeded, thereby ceasing to provide protection from surges.

Warranty replacement procedure

  1. Call our U.S.-based Consumer Care at 1-844-816- 0320 to get a Return Authorization Number (RA#), shipping instructions and a prepaid return address label.
  2. Return the said surge protector, freight prepaid, to us. Surge protectors returned to us must have an RA# included in the mailing address to be accepted.
  3. The original purchaser will be asked to send the surge protector, a copy of the sales receipt for the product, your name, address, phone number and a description of the problem.

Connected Equipment Warranty Equipment Replacement Guarantee for Surge Models SPS6024BC/37, SPS6024CR/37, SPS6024GR/37, SPS6024TL/37, SPS6024WA/37. Maximum Warranty Amount: $25,000 (USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection when lightning strikes nearby power line, the house, service entrance or antenna. The warranty is void if a power disturbance damages your equipment through the coax, phone or network lines.

We will pay up to the maximum warranty amount offered for the surge protector purchased to repair or replace up to an amount equal to the fair market value or the original purchase price, whichever is less, of your electronics equipment, if damaged by a transient surge (except those caused by direct lightning), within the life* of the surge protector, while properly and directly connected to this surge protector. WE DISCLAIM AND ASSUME NO LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE OR DATA OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS INTERRUPTION OR OTHER DAMAGES DUE TO LOSS OR DAMAGE TO EQUIPMENT, SOFTWARE OR DATA. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that may vary from state to state.

This warranty is secondary to any existing coverage of any connected equipment, including but not limited to, any manufacturer’s warranty, extended warranties, or insurance coverage.

To qualify for a connected equipment warranty:

  1. All connected equipment must be safety certified by a Nationally Recognized Testing Laboratory.
  2. The said surge protector must be plugged into properly wired and grounded outlets, no extension cords, adapters, other ground wires or electrical connectors may be used, with the sole exception of other standard 120V products approved for that use. The installation must comply with all applicable electrical and safety codes set forth pursuant to the National Electrical Code (NEC).
  3. Any claim under the warranty policy must be made within 15 days of the date of the alleged damage to the connected equipment.

For connected equipment coverage, the following conditions must be satisfied:

  • A. All equipment eligible for warranty coverage must be plugged directly into said surge protector. Equipment connected to the protected equipment, but not plugged directly into the surge protector will not be covered.
  • B. The equipment must have been damaged by a covered power disturbance that passed through the said surge protector.
  • C. The said surge protector must be damaged from the power disturbance.
  • D. The said surge protector’s protection capacity must not have been exceeded.

Connected equipment claim procedure:

  1. Call our U.S.-based Consumer Care at 1-844-816- 0320 to get a Return Authorization Number (RA#), shipping instructions and a prepaid return address label.
  2. After you have received the prepaid return address label, return the surge protector, freight prepaid, to us. Surge protectors returned to us must have an RA# included in the mailing address to be accepted.
  3. We will determine whether the damage to your equipment is covered by this warranty policy. If you are covered, a claims adjuster will contact you and we will do one of the following at our own discretion:
    a. Authorize a service centre to repair damaged equipment.
    b. Replace damaged equipment with equivalent or better.
    c. Reimburse customer the fair market value of the damaged equipment.
    d. Reimburse customer the initial purchase price of the damaged equipment (customer to provide dated bill of sale).
  4. We retain the right to determine whether the damage to the connected equipment is due to said surge protector failure by requesting that damaged equipment be sent to us for inspection.

FCC Statement

Suppliers Declaration of Conformity | Models: SPS6024BC/37, SPS6024CR/37, SPS6024GR/37, SPS6024TL/37, SPS6024WA/37 Jasco Products Co., 10 E. Memorial Rd., Oklahoma City, OK 73114, www.byjasco.com.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

https://byjasco.com/51824i
 byjasco.com/deals
byjasco.com/power

WARNING
RISK OF ELECTRIC SHOCK

  • DO NOT USE IN WET LOCATIONS
  • KEEP CHILDREN AWAY
  • USE INDOORS ONLY
  • FULLY INSERT PLUG

RISK OF FIRE

  • DO NOT EXCEED ELECTRICAL RATINGS

NOT FOR USE WITH

  • AQUARIUMS OR OTHER WATER-RELATED PRODUCTS
  • GENERATORS AND POWER INVERTERS
  • MEDICAL LIFE-SUPPORT PRODUCTS

MADE IN CHINA

Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of Jasco Products Company, and Jasco Products Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114 is the warrantor in relation to this product.

This product comes with a limited-lifetime warranty. Visit www.philips.com/support for warranty details.

Questions? Contact our U.S.-based Consumer Care at 1-844-816-0320 between 7AM-8PM, M-F, Central Time.

byjasco.com/recycle