Honeywell VNT5150H1000 Filter Replacement Kit HRV/ERV Instructions
Filter Replacement Kit HRV/ERV
VNT5150H1000 / VNT5150E1000
VNT5200H1000 / VNT5200E1000
VNT5070H1000 / VNT5070E1000
Part N° 50055113-009
Part N° 50055113-010
Part N° 50055113-026
READ AND SAVE THESE INSTRUCTIONS
Read all instructions and WARNINGS carefully before beginning.
- Four times a year or as needed, vacuum the filters.
- Replace the filters once a year.
- STEP 1: Disconnect the power supply.
- STEP 2: Unlatch the door panel.
- STEP 3: Remove the door panel by sliding it off the hinges.
- STEP 4: Remove the filters and vacuum. (Figure 1 and 2) (Skip this step if you are replacing the filters.)
- STEP 5:
HRV MODEL: Once a year or as needed, slide out the heat recovery core. Vacuum the four surfaces, let soak in warm water for 15 minutes, then spray rinse and let dry. (Figure 3)
ERV MODEL: Once a year or as needed, slide out the energy recovery core. Vacuum the ERV core or rinse with cold water.
Do not use soap, a dishwasher, or a pressure washer. (Figure 3) - STEP 6: Once a year or as needed, clean the interior of the unit (walls and drain pan) with a mild non-abrasive soap. It is recommended to use products that are environmentally friendly. (Figure 4)
- STEP 7: Replace Core.
- STEP 8: Replace and dispose of the old filters in accordance with your municipal guidelines.
- STEP 9: Reinstall and latch door panel.
- STEP 10: Connect the power supply.
Note: The model VNT5070 has all ports on top of the ventilator.
Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
1-800-468-1502
33-00570EF—01 M.S. 01-21
Printed in the United States
© 2021 Resideo Technologies, Inc. All rights reserved.
The Honeywell Home trademark is used under license from Honeywell International, Inc.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
