Miele PFD 101 Commercial Dishwasher Instruction Manual
Commercial Dishwasher
PFD 101 / PFD 101i
Operating instructions
and damage to the machine.
| Test standard: | AS/NZS 2007.1, AS/NZS 2007.2; AS/NZS 6400 |
| Standard programme (for energy label): | ECO |
| Capacity: | |
| Detergent amount: | 32.5 g |
| Rinse aid dosage: | Setting 3 |
You can find information on adjusting the rinse aid dosage in the “Rinse aid” section of this booklet.
The door opens automatically during the drying phase.
Do not close the door until the drying test has finished.
Upper basket setting:
| Position: | Bottom |
| FlexCare cup rack (if available): | Left lower position, right upper position |
Loading examples
Pictures illustrating how to load the dishwasher for each model (see data plate) are
shown on the following pages.
Picture 1: Upper basket
Picture 2: A lower basket
Picture 3: Cutlery basket
Do not lower or remove the basket inserts.
Squeeze and remove the bottle holder from the lower basket (if available).
Comparison tests
Capacity
Cutlery basket
1 fork
2 soup spoons
Programme chart
| Programme | Application | Detergent The following dosages are based on Miele detergents. Please follow the manufacturer’s instructions. |
| Detergent compartment, | ||
| For fresh, non-sticky food residues. | 20-25 g or 1 tab | |
| For moderately dried food residues. | 20-25 g or 1 tab | |
|
|
For burnt-on, stubborn, dried-on food deposits containing starch or protein 1). | 20-25 g or 1 tab |
| Special plastics programme. | 20-25 g or 1 tab | |
|
|
Special glassware programme. | 20-25 g or 1 tab |
| Special hygiene programme for hygienically demanding crockery. | 20-25 g or 1 tab | |
| For rinsing heavily soiled items, e.g. for initial removal of soil or to prevent residues drying on to dishes when a complete programme does not yet need to be run. | ||
| Energy-saving programme for normally soiled food residues. | 20-25 g or 1 tab |
*) This programme is the most efficient in terms of its combined energy and water consumption for cleaning crockery with a normal level of soiling. (fixed programme sequence which cannot be altered)
1)see “Detergent”
| Programme sequence | |||||
| Pre-wash | Main wash | Interim rinse | Final rinse | Drying | AutoOpen |
| X 60-65 °C 2) 1 min |
X 40 s |
X 65 °C 3) 30 s |
(X) 20 min 4) |
(X) | |
| X 65 °C 6 min |
X 3 min |
X 65 °C 3) 2 min |
(X) 30 min |
(X) | |
| X 6 min |
X 75 °C 6 min |
X 3 min |
X 65 °C 3) 2 min |
(X) 30 min |
(X) |
| X 6 min |
X 50 °C 1 min |
X 5 min |
X 60 °C 1 min |
X 30 min |
(X) |
| X 50 °C 1 min |
X 3 min |
X 50 °C 2 min |
(X) 20 min |
(X) | |
| X 8 min |
X 60 °C 10 min |
X 3 min |
X 82 °C 2 min |
X 30 min |
(X) |
| X Cold 10 min |
|||||
| X 51.5 °C 44 min |
X 4 min |
X 48 °C 10 min |
X 127 min |
(X) | |
X = stages included in a programme
(X) = optional stages which can be selected (see “Programme options – Options”)
2)The temperature which is able to be reached depends on the load items, size of load and the water intake temperature.
3)Optional temperature increase to 82 °C.
4)With temperature increased to 82 °C, drying time increases to 30 min.
| Programme | Consumption 6) |
Duration 6) | |||||||||
Electrical energy |
Water | ||||||||||
| Cold water 15 °C |
Hot water 55 °C |
Cold water 15 °C |
Hot water 55 °C | ||||||||
| 2.1 kW | 7.3 kW | 2.1 kW |
7.3 kW | 2.1 kW | 7.3 kW | 2.1 kW | 7.3 kW | 2.1 kW | 7.3 kW | ||
| 1.4 kWh | 0.9 kWh |
14.7 I | 53 min 7) |
22 min 7) |
36 min 7) |
17 min 7) | |||||
| 1.5 kWh | 1.0 kWh |
0.9 |
14.81 | 65 min 7) |
34 min 7) |
49 min 7) |
31 min 7) | ||||
| |
1.7 kWh | 1.0 kWh |
19.2 I | 79 min 7) |
48 min 7) |
58 min 7) |
43 min 7) | ||||
| 1.3 kWh |
1.2 kWh |
0.6 |
0.5 kWh |
19.5 I | 90 min | 65 min | 68 min | 60 min | |||
| |
1.0 kWh | 0.4 kWh |
15.3 I | 43 min 7) |
23 min 7) |
27 min 7) |
19 min 7) | ||||
| 1.9 kWh |
1.8 kWh |
1.2 |
1.1 kWh |
19.2 1 | 85 min 7) |
53 min 7) |
65 min 7) |
47 min 7) | |||
| 0.02 kWh | 0.02 kWh |
4.5 I | 13 min | 13 min | |||||||
6)Values are calculated in accordance with EN 50242 for a rated load of 2.1 and 7.3 kW. In practice considerable variations may be noted due to differing conditions.
The duration displayed is adjusted to the on-site conditions.
7) The figure refers to the wash duration without drying.
| Programme | Consumption 6) | Duration 6) | |||||||||
| Electricity | Water | ||||||||||
| Cold water 15 °C |
Hot water 55 °C |
Cold water 15 °C |
Hot water 55 °C | ||||||||
| 3.2 kW | 5.1 kW | 3.2 kW |
5.1 kW | 3.2 kW | 5.1 kW | 3.2 kW | 5.1 kW | 3.2 kW | 5.1 kW | ||
| 1.4 kWh | 0.9 kWh |
14.7 I | 39 min 7) |
28 min 7) |
28 min 7) |
20 min 7) | |||||
| 1.5 kWh | 1.0 kWh |
0.9 kW h |
14.8 I | 49 min 7) |
39 min 7) |
39 min 7) |
32 min 7) | ||||
| |
1.7 kWh | 1.0 kWh |
19.2 I | 65 min 7) |
55 min 7) |
50 min 7) |
46 min 7) | ||||
| 1.0 kWh | 0.4 kWh |
15.3 I | 34 min 7) |
27 min 7) |
23 min 7) |
21 min 7) | |||||
| 2.0 kWh |
1.9 kWh |
1.3 kWh |
1.2 |
19.2 I | 72 min 7) |
62 min 7) |
58 min 7) |
53 min 7) | |||
| 1.3 kWh |
1.2 kWh |
0.6 kWh |
0.5 |
19.5 I | 79 min | 70 min | 64 min | 61 min | |||
| |
0.02 kWh | 0.02 kWh |
4.5 I | 13 min | 13 min | ||||||
6) Values are calculated in accordance with EN 50242 for a connected load of 3.2 kW and 5.1 kW. In
practice considerable variations may be noted due to differing conditions.
The duration displayed is adjusted to the on-site conditions.
7) The figure refers to the wash duration without drying.
Consumption data in ECO programme
| Programme | Consumption 8) |
8)Duration (Program Time) | |||
| Electrical energy | Water 20 °C | ||||
Coldwater |
Hot water 60 °C |
Coldwater |
Hot water 60 °C | ||
| 0.6 kWh | 0.9 kWh | 13.1 L | 178 min | 171 min | |
8) Values for the ECO programme were calculated under standardised testing conditions. In practice, the selected settings, programme options or operating conditions may result in different values.
M.-Nr. 11 497 960