Brother DCP-1610W(E) Wireless Mono Laser Printer Installation Guide
brother DCP-1610W(E) Wireless Mono Laser Printer
Unpack the machine and check the components
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
NOTE:
- The components included in the box and the AC power plug may differ depending on your country.
- The illustrations in this Quick Setup Guide are based on the MFC‑1910W.
- You must purchase the correct interface cable for the interface you want to use.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than 2 metres (6 feet) long.
Secure Network Access
Your machine’s default password is on the label on the back of the machine (preceded by “Pwd”).
We strongly recommend you change it to protect your machine from unauthorised access.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than 2 meters (6 feet).
Network cable
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or 100BASE-TX Fast Ethernet Network.
Remove the packing materials and install the toner cartridge
Load paper in the paper tray
Connect the power cord and turn on the machine
Select your language (Only for certain models)
Depending on your machine, you may be required to set your country or language.
If required, follow the on‑screen instructions.
Change your language
- (DCP models)
1. Press Menu, and then press ▲ or ▼ to choose 1.General Setup.
2. Press OK.
(MFC models) Press Menu, 0, 0, and go to step 3. - Press ▲ or ▼ to choose 0.Local Language, and then press OK.
- Press ▲ or ▼ to select your language, and then press OK.
- Press Stop/Exit.
Connect the machine to your computer/mobile device.
- Windows® PC with a CD‑ROM drive, go to step 6A
- Windows® PC without a CD‑ROM drive, go to step 6B
- Macintosh, go to step 6B
- Mobile device users with a WPS/AOSS™‑supported access point/router, go to step 6C
Configuration using the CD‑ROM (Windows®)
Configuration without using the CD-ROM (Windows® without CD-ROM drive or Macintosh)
Download the full driver and software package from the Brother Solutions Center.
(For Windows®) solutions.brother.com/windows
(For Macintosh) solutions.brother.com/mac
After you download the driver and software package, follow the on-screen instructions until the Connection Type screen appears. Refer to 5A Configuration using the CD-ROM (Windows®).
One-push wireless setup for mobile devices (Wireless models only)
If your wireless LAN access point/router supports automatic wireless (one-push) setup (WPS/AOSS™), you can set up your machine without using a computer.
Print using your mobile device
Download “Brother iPrint&Scan” to start using your machine with mobile devices.
Brother support web site http://support.brother.com