Philips UV-C Disinfection Desk Lamp User Manual

Philips UV-C Disinfection Desk Lamp

Philips UV-C disinfection desk lamp
This user manual provides important information on the application and operation of this UV-C device. You should always use and store this UV-C device in accordance with this user manual.

Caution!

• No person or animal should be present in the room at the time of usage, due to high risk of harm to eyes and skin.
• The UV-C device is not designed and/or intended to be used to disinfect medical devices or for med-ical purposes; Signify excludes any and all liability for any such improper use.
• The UV-C device cannot be used for disinfection of human skin.
• Do not heavily bend or drag the cord, to prevent fire and electric shock. The cord is not replaceable.
• Do not use the damaged cord.
• The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
• Do not use the UV-C device as normal lighting.
• This UV-C device should only be used in a stable upright position.
• Do not use this UV-C device when it leans, is upside down or has fallen from a flat surface.
• This UV-C device should be put in the center of the room, on the floor or on a table (with a height no more than 1.2 meter).
• The disinfection effect is dependent on the time of exposure to UV-C light.
• Keep it well stored when it is not working to prevent causing harm to eyes and skin of humans and animals.
• Always store the UV-C device in the supplied pre-sentation case.
• This UV-C device should not be opened or dismantled.
• Switch the power off when cleaning the product .
• The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
• This UV-C device only works under dry conditions, its not water-proof.

Warning:

Plants and/or materials that are exposed to UV-C for a long time may become damaged and/or discolored

WARNING UV-C
emitted from this product. Avoid eye and skin exposure to unshielded product.
Follow installation instructions and user manual.
Wireless specification:
Wireless RF mode frequency band: 5725 – 5875 MHz
Maximum transmitted power: <1mW
Hereby, [Signify] declares that the radio equipment type [UV-C Disinfection desk lamp] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.philips.com/lighting

Control panel:

Power button, hold 3 seconds to unlock/press once to start working.
Timer button, press once to choose working min.

Press any button to stop working and back to lock mode. The UV-C device is locked when the LED indicators light one by one.
The UV-C device doesn’t work properly when the LED indicators are in light flash mode, please contact customer service.

Operation guide

1. Power on, the UV-C device is in lock mode, hold power button for at least 3 seconds to unlock.
2. Press timer button to choose disinfection duration, there are 3 options, 15min., 30min. or 45min.
3. Press power button to start working mode, please leave the room and close the door, and the device will start to disinfect in 30 seconds when sensor can’t detect any human or animal.
4. The device will go back to lock mode when routine is completed.
5. Please unplug the device when routine completes.
   •  The sensor can detect human or animal within 5 meters radius.
   • When human or animal enters the 5 meters radius, the UV-C device will turn off light and switch to lock mode.

Language selection mode

1. Hold both power and timer button simultaneously for 3 seconds
2. Press timer button for language selection, there are 4 languages for selection: French , German, Spanish and English
3. Press power button to save and exit the language selection mode

Application

Disinfection effectiveness will vary depending disinfection timing, distance and type of surface/object.

Product Specification