Philips 50072758 GoZero Smart UV Bottle 50072758 GoZero Smart UV Bottle User Manual

Go Zero
Hydration bottle

Go Pure,
Go Hot,
Go Cold,
Go Anywhere !

Goodbye. single-use plastic bottles.
Goodbye, musty reusable bottles.
Hello, self-cleaning smart bottle!

Thank you for being part of the solution, and helping to reduce single-use plastic waste. Stay hydrated, and enjoy!

  1. UV-C activation button
  2. Indicator light
  3. Magnetic charge port
  4. Cap
  5. UV-C module
  6. Max water line
  7. Vacuum insulated stainless steel bottle
  8. USB cable

Getting started

  1. Unlock the bottle
    Clean the bottle except for the cap with mild detergent by hand or in the dishwasher (max Sot). Rinse the cap with clean water. Screw on the cap, press and hold the UV-C activation button for 3 seconds to unlock the bottle for the first time. The indicator light will flash blue. telling you the bottle is ready to use.
  2. Power up
    Connect the USB cable with the charging port on the cap. and plug the USB into any USB wall charger until the battery is fully charged.
    Notes: DO NOT charge with any USB cable other than the USB cable provided with the bottle.
    Slowly-flashing green light
    Charging
    Steady green light
    Fully charged –
    Steady orange light
    Low battery. please recharge the bottle as soon as possible.
    Pulsing red light*
    Out of battery
    Steady red light
    Something is wrong. Visit www.phitips.com/water for troubleshooting and support.

When the bottle is out of battery, it will be off completely. Please recharge and unlock the bottle according to step 1.

Sanitizing the bottle

  1. Self-cleaning
    The UV-C will be activated every 2 hours automatically to keep the bottle clean (10 seconds per cycle with slowly-flashing blue light). This function can be turned off by pressing and holding the UV-C button for 3 seconds until it shows steady purple light.
  2. Sanitizing the bottle
    After you enjoy your favorite hot and cold drinks, hand wash the bottle or put it in the dishwasher except for the cap. When cleaning is completed, you may screw the cap on and press the UV-C button once to further sanitize the bottle. This helps to prevent the unpleasant smells from growing inside the bottle.
    Notes: This product is not intended to purify liquids other than water.

Purifying water

  1. Fill the bottle with water up to the max water line.
  2. Screw the cap on, and press the UV-C button once to activate the purification function. The indicator light will flash blue slowly for 3 minutes. You may shake the bottle gently during the purification process to ensure an even result. Enjoy freshly purified water when the light is off.
  3. While using the bottle in the backcountry or during travels, we recommend running the purification cycle twice to ensure the safety of the water. It’s also advised to take additional precautionary methods depending on the water source quality since the bottle doesn’t filter out contaminants such as particulates. chemicals or heavy metals.

Notes:
– Do not interrupt the purification cycle by removing the cap or pressing the button.
– This product is not intended to purify liquids other than water.

Safety first

NEVER activate the UV-C function when the cap is taken outside the bottle. If it’s activated accidentally, the indicator light will flash orange for 5 seconds to remind you, and the UV-C function will be off automatically.
If the liquid is too hot (above sortmoV) or too cold ( below 4t/39.2’F) inside the bottle, the safety protection mode will be on automatically to protect the UV-C module, and the indicator light will flash orange for 10 seconds.

Warnings & Cautions

Please read and understand the following prior to operating this product. Always follow the instruction when using the GoZero'” Smart bottle and the cap. Improper operation of the Smart bottle may cause injury.

– Always use the clearest and reliable water source possible when using the bottle in the backcountry or during travels. Improper usage of GoZeron” Smart bottle increases your risk of exposure to harmful microorganisms and getting a gastrointestinal illness. Since the bottle doesn’t filter out contaminants, it’s recommended to apply filtration first, then use the bottle to further purify the water. GoZero’s Smart should only be used to purify water from 4C/39.2V to 60t/140F.
– This product Is not intended for usage by persons with reduced physical sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. Children over 8 years old should be supervised to ensure that they do not play with appliances. This product is not suitable or intended for use by children under 8 years old. Keep the product out of the reach of small children. – Do not look directly at the UV-C light. It can irritate eyes and skin or may otherwise be potentially harmful. – The cap of GoZero”‘ Smart bottle should be used exclusively with the Smart bottle. The efficacy of the purification and sterilization has only been tested with the GoZeroth Smart bottle. We cannot guarantee the effectiveness when it’s used with alternative bottle designs.
– Never tamper with, open, or alter the GoZero'” Smart bottle or the cap. If the GoZeroTs Smart bottle or any component of it malfunctions or fails to perform as expected, stop use immediately. Do not open or attempt to repair the GoZero”‘ Smart bottle or its components.
– The UV-C light is a high voltage device. Do not open, expose, modify or touch internal circuitry as this can lead to high voltage shock. Removal or tampering with the electronic circuit board of UV-C light assembly may cause injury or damage to the user or the product and will void all warranties.
– To prevent danger or shock hazards, keep and store this product away from rain or liquid. Do not use the charger near water, for example, near a bathtub, washbowl, kitchen sink, laundry tub, or swimming pool.
– Clean the outside of the product with a clean moist cloth. Never use any strong cleaning sprays or fluids, or similar chemicals on the product.
– When recharging, only connect the adaptor as described in the product instructions or user manual. Do not charge with any USB cable other than the USB cable provided with your Smart bottle. Do not remove the bottle cap while purifying cycle is in progress. if the cap is removed during a purifying cycle, the GoZerolm Smart bottle’s automatic safety protocols will cancel the cycle and turn off the UV-C light to avoid any harm from contact with UV light to eyes or skin.
– To cancel a purifying cycle, first press the button on top of the cap, then safely remove the cap.
– Do not use as a light source.
– Do not expose the cap to temperatures below freezing or above 60t/140 ‘F.
– The cap’s UV-C light is not intended to disinfect water on the lip or exterior surfaces of the bottle where the light does not reach. It is not intended to disinfect the outer surfaces of a drinking container, i.e. those that typically contact the mouth when drinking. Be certain that the bottle and cap have been properly cleaned prior to use. – As with any water treatment system. you should always have a backup method available.
– Do not allow the impact to the UV-C light. If the cap or UV-C light assembly is cracked, chipped, or damaged, do not operate.
– While carefully controlled microbiological testing has been conducted, the actual use of the UV-C function in the field may produce results that vary from laboratory test data. – The battery must be removed from the appliance before it is scrapped.
– This appliance contains batteries that are non-replaceable.

Guarantee & Service

If you need information or if you have any problems, please visit the Philips website at www.philips.com/water or contact the consumer care center in your country. If there is no consumer care center in your country, go to the local dealer Find more warranty details on www.philips.com/water.

Disclaimer
AquaShield and its affiliated entities and related companies shall be neither liable for any damages arising out of or because of the use of the GoZeroTM Smart bottle for any purpose other than for which it is clearly intended, nor for any malfunction resulting from the failure of the user to strictly follow the usage and safety information in this manual.

Disposal
The GoZero'” Smart bottle cap contains a rechargeable lithium-polymer battery, therefore dispose of the product in accordance with applicable local laws and regulations. Contact your local town or city officials for more information regarding the disposal.

Removing the rechargeable battery before disposal (for EU based users)
Make sure the battery is completely empty when you remove it.

  1. Remove the silicone cover. (A-1)
  2. Remove the top plastic cover. (A-2)
  3. Pry PCB loose. (A-3)
  4. Pull out the wires from PCB. (A-4)
  5. Remove the batty. DO NOT puncture the battery. (A-5)

Before disposal, do not place the product together with household waste. You should hand it over to a government-designated recycling center. By doing this, you help to preserve the environment.

Please keep this user manual for future reference.

Thanks for choosing Philips GoZeroTM bottles, and helping to reduce single-use plastic waste.
Learn more about the Philips GoZero range on www.philips.com/water.

Specifications are subject to change without notice

© 2020 AquaShield
All rights reserved.
The Philips trademark and the Philips Shield Emblem have registered trademarks of Koninklijke Philips N.V. used under license. This product has been manufactured by and is sold under the responsibility of Hong Kong AquaShield Health Technology Company
Limited and Hong Kong AquaShield Health Technology Company
Limited is the warrantor in relation to this product.
Rev A JUN 20