Electrolux EWD 1214 I Portable Washer Dryer Instruction Manual

The serviced apartment company
Operating Instructions – Washer Dryer Electrolux EWD 1214 I
Detergent dispenser drawer

The Control Panel

1. Detergent dispenser drawer
2. Drying indicator light (This light illuminates when the machine is drying)
3. Drying time selector dial
   Graduated up to 120 mins for cotton and synthetics, this dial allows you to select the desired drying time according to the type and quantity of laundry and the required degree of dryness. Blue sector – for cotton, Green sector – for synthetics.
   Turn the dial clockwise only.
   Depress the dial to pop it out.
   Cooling Phase
   To allow the laundry to cool down, a cooling phase starts automatically 10 minutes before the end of drying and this phase must in no circumstances be reduced or interrupted.
4. Spin speed reduction button
   By depressing this button the spin speed is reduced as follows:
   – Cotton and linen from 1200rpm to 650rpm
   – Synthetics and wool from 850rpm to 650rpm
   – Delicates from 650rpm to 450rpm
5. Quick wash button
   By depressing this button on programs A, B, C, D, and H the wash time is reduced. This is suitable only for garments that are lightly soiled.
6. Super Rinse button
   By depressing this button on programs for cotton and linens the machine will perform an additional rinse. This is recommended for people who are allergic to detergents and in areas where the water is very soft.
7. Rinse Hold button
   Press this button to make the machine stop with water in the drum after the last rinse. This prevents any creasing which may occur if the clothes are left damp in the drum.  When it is convenient for you to empty the machine, simply press this button again so that the machine can proceed to drain and spin, or turn the dial to the drain program “R”. If this button is not activated, the washing programs will end with a spin. (This button is not compatible with the automatic washing and drying program.)
8. On/Off button
   By depressing this button the machine starts operating. When depressing it again, the machine stops.
9. Mains-on light
   This light will illuminate when the machine starts working and goes out when the On/Off button is depressed again to switch the machine off.
10. Program selector dial
    With the program selector dial, you choose the desired washing and drying program. Turn it clockwise. Depress the dial to pop it out. Before setting the dial to any position the machine must be switched off by depressing the On/Off button.

Operating sequence washing

1. Load the laundry
2. Measure out the detergent and pour it into the main wash compartment (II). If you wish to carry out the prewash, pour detergent into the compartment marked (I).
3. Measure out the fabric softener if required and pour into the compartment marked not exceeding the ‘Max’
   mark in the drawer.
4. Select the required option (s)
   Depress Spin Reduction and/or Quick Wash and/or Super Rinse and/or Rinse Hold button, if required.
5. Select the required program. Turn the program selector dial clockwise to the desired program.
6. Start the machine by pressing the On/Off button. The mains on the light will illuminate and the machine will start.
7. At the end of the program, the machine stops automatically. If you have pressed the Rinse Hold button the machine will stop with the water of the last rinse left in the tub, to prevent the fabric from creasing. To drain the water and spin, release the same button. To drain only, select program “R”. The door is controlled by a safety device that releases 2 minutes after the end of the program. Switch the machine off by depressing the On/Off button again, the mains-on light goes out.

Operating sequence drying

1. Load the laundry
2. Select the program by turning the program selector dial clockwise to the appropriate drying program.
3. Select the required time (See program chart) turn the drying time selector dial clockwise to the correct time setting in the blue sector.
4. Start the machine by depressing the On/Off button, the mains-on light and drying light will illuminate and the machine starts operating.
5. At the end of the program, the machine stops automatically and the drying light goes out. The door is controlled by a safety device which releases 2 minutes after the end  of the program. Switch the machine off by depressing the On/Off button again, the mains-on light goes out. If the laundry is still too damp, select a further brief drying time, bearing in mind that during the last 10 minutes the appliance carries out a cooling and anticrease phase.

Operating sequence washing and drying

Follow this sequence if you intend to wash and dry automatically

1. Load the laundry
2. Measure out the detergent and fabric softener
3. Select the required program
   Turn the program selector dial clockwise to the appropriate program.
4. Select the required option, depressing the quick wash button if required.
   
   In order to save energy and to avoid too long drying times we suggest not to reduce the spin speed when you wash and dry automatically.
5. Select the required time following indications given in the program chart on the following page. Turn the time selector dial clockwise to the appropriate number of minutes in the green sector.
6. Start the machine by pressing the On/Off button, the mains-on light comes on and the machine starts operating.
7. At the end of the program, the machine stops automatically and the drying light goes out. The door is controlled by a safety device which releases 2 minutes after the end  of the program. Switch the machine off by depressing the On/Off button again, the mains-on light goes out. If the laundry is still too damp, select a further brief drying time, bearing in mind that during the last 10 minutes the appliance carries out a cooling and anticrease phase.

Washing programs for cotton and linen

Programs for synthetics, mixed fabrics, delicates, and wool

Drying programs

www.sacoapartments.com
welcome