Panasonic EH-SQ10 Facial Cool Putter Instruction Manual

Panasonic EH-SQ10 Facial Cool PutterInstruction Manual

Operating Instructions
(Household) Facial Cool Putter
Model No. EH-SQ10

Thank you for purchasing this Panasonic product. Before operating this unit, please read these instructions completely and save them for future use.

Safety precautions

Parts Identification

  • (A) Cold plate
  • (B) Air inlet
  • (C) Main switch [0/1]
    1:ON
    0:OFF
  • (D) Appliance socket
  • (E) Air outlet
  • (F) Cord
  • (G) AC adaptor
  • (H) Power plug
  • (I) Appliance plug

Notices for use

  • At the beginning, it is advised to use this product no more than 2 – 3 times in a week. You can use it once a day (about 2 minutes) after a month. Adjust the frequency and duration depending on your skin condition.
  • Skin flush or pruritus may occur during use. Immediately see a doctor if the symptom is not mitigated after you stop using this product.
  • Do not use this product when wearing makeup.
  • Use this product only in the range of 15 j 40 °C. Cold injury may occur below 15 °C. Product failure is more likely to occur at higher temperature.
  • Do not apply this product to the same part of your body for a long time.
  • Do not block the air inlet or the air outlet (the shaded portion in the illustration). Doing so may cause not cold on the cold plate.

How to use

  • Check if the surface of the cold plate is damaged or dirty before use.
  1. Plug the appliance plug into the appliance socket and insert the AC adaptor into a household outlet.
  2. Set the main switch to “1”. Operation sound should be audible when power is turned on. The cold plate will become cold after about 30 seconds.
  3. Gently touch your face with the cold plate. It will take about 1 minute to finish the cold compress on your whole face.


    ■ Tips
    • Move over your face with a gentle patting motion.
    • Move from inside to outside of your face.
    • Actions on your left face and right face should be symmetrical.

  4. Set the main switch to “0” and unplug the AC adaptor from the household outlet after cold compressing. The cold plate may be temporarily warm, but will restore to normal temperature after power-off.
Recommended method to use with facial steamer

■ Notice for use

  • Do not directly blow this product by steam.

Recommended use mode (take the facial steamer running for 6 minutes as an example)

After use

  • Use moisturizing skin care products to take care of your
    face after using this appliance. If you do not take care of your skin, water will evaporate from it, making it dry.

Maintenance of facial cool putter

Do not use paint thinner, benzene, alcohol, etc., to clean the unit. Doing so may cause failure, cracking or discoloration of the main body. Wipe with a cloth soaked in soapy water and wrung tightly.

Troubleshooting

Specifications

Panasonic Corporation
http://panasonic.net
© Panasonic Corporation 2014

Printed in China
EH9210SQ101421 Y0914-0