Cisco CS-DESKPRO-K9 Collaboration Device User Manual

CISCO CS-DESKPRO-K9 Collaboration Device User Manual

Safety Instructions – Warnings

Read the installation instructions before using, installing or connecting the system to the power source.

Ultimate disposal of this product should be handled according to all national laws and regulations.

No user-serviceable parts inside. To avoid risk of electric shock, do not open.

Installation of the equipment must comply with local and national electrical codes.

Printing instructions

  • Comments:
  • Number of pages: 2
  • Two sided printing: Yes
  • Folding: 5 folds, “accordion” foldingpamphlet size after folding: 110 x 160 mm
  • Printing method: Grayscale
  • Paper quality: 70 g/m2 (or nearest equivalent)
  • Paper size: 660 x 160 mm, Landscape
    Do not archive any files. You must download files from Cisco’s secure external file sharing tool, Doc Exchange, for every printing.
    Remove this page before printing

National Restrictions

This section identifies countries that have additional requirements or restrictions.

For FCC (US)

Contains FCC ID: LDK073002357 Modification Statement (§15.21): Changes or modifications to the equipment not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Compliance Statement (§15.19):

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Class B Interference Statement (§15.105b):

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference, to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • reorient or relocate the receiving antenna
  • increase the separation between the equipment and receiver
  • connect the equipment into an outlet on a circuit different from that to which the receiver is connected
  • consult the dealer or an experienced radio/ TV technician for help

For IC (Canada)

Contains IC ID: 2461N-073002357

Interference Statement (RSS-GEN, Section 8.4)

This Device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 5150-5250 MHz is limited to use indoors only.

Exposure statement (§2.1091) (US, Canada)

To comply with FCC/IC RF exposure limits for general population / uncontrolled exposure, the antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

EU Directive 2014/53/ EU-Compliance Information for the Cisco Collaboration series Wireless LAN products.

Scope

The information in this document is applicable to the Cisco Collaboration series wireless LAN products that currently includes the Webex Desk and Webex Desk Mini devices. These products are intended to be placed on the market within the European Union, Lichtenstein, Switzerland, Iceland, Norway, Turkey and other countries that have implemented the EU Directive 2014/53/EU.

Simplified EU Declaration of Conformity

This declaration is only valid for configurations (combinations of software, firmware and hardware) provided and/or supported by Cisco Systems for use within the EU or countries that have implemented the EU Directives and/ or spectrum regulation. The use of software or firmware not supported/provided by Cisco Systems may result that the equipment is no longer compliant with the regulatory requirements.

English: This equipment is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/ЕU.

Note: The full declaration of conformity for these products can be found at:

A Cisco.com login is required to access this document. You can register for a Cisco.com account if you don’t have one.

Art. 5th – Resolution Nº 680/2017 (Brazil)

This equipment is not entitled to the protection from harmful interference and may not cause interference with duly authorized systems.

On our web site you will find an overview of the worldwide Cisco contacts.
Go to:
https://www.cisco.com/web/siteassets/contacts
Corporate Headquarters Cisco Systems, Inc. 170 West Tasman Dr. San Jose, CA 95134 USA

Where to Find Product Documentation

Product Information

https://help.webex.com
https://www.cisco.com/go/telepresence/docs

Warranty Information

https://www.cisco.com/go/warranty

Regulatory, Compliance, and Safety Information

https://www.cisco.com/go/telepresence/docs

End User License Agreement and License Information

https://www.cisco.com/go/eula
https://www.cisco.com/go/license

Antennas

The device has integrated antennas which cannot be replaced.

Radio Channels

The devices use World Mode (802.11d) to determine operating channels and transmit powers.

Intended Use

This product is a collaboration endpoint for use primarily in an office environment. For indoor use only.

Installation

Minimum separation distance: 10 cm /4 in