HP 410 Slim Bluetooth Mouse User Manual
Product Notices
Regulatory Notices
This document provides country- and region-specific non-wireless and wireless regulatory notices and compliance information for your product. Some of these notices may not apply to your product.
Federal Communications Commission notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio or television technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
For questions regarding this product, write to
HP Inc.
1501 Page Mill Road
Palo Alto, CA 94304
email [email protected], or call HP at 650-857-1501.
To identify your product, refer to the part, series, or model number located on the product.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by HP may void the user’s authority to operate the equipment. Cables To maintain compliance with FCC Rules and Regulations, connections to this device must be made with shielded cables having metallic RFI/EMI connector hoods.
Products with wireless LAN devices or HP Mobile Broadband Modules
This device must not be co-located or operating in conjunction with any other antenna or transmitter.
During normal operation of tablet PCs and notebook computers with displays equal to or less than 30.5 cm (12 inches): To avoid the possibility of exceeding the FCC/Industry Canada radio frequency exposure limits, human proximity to the antennas should not be less than 2.5 cm (1 inch). To identify the location of the wireless antennas, refer to the computer user guides included with your computer.
During normal operation of notebook computers with displays greater than 30.5 cm (12 inches): To avoid the possibility of exceeding the FCC/Industry Canada radio frequency exposure limits, human proximity to the antennas should not be less than 20 cm (8 inches), including when the computer display is closed. To identify the location of the wireless antennas, refer to the computer user guides included with your computer.
Declaration of Conformity
Products bearing the CE marking and UK marking compty with one or more of the following EU Directives and the applicable UK Statutory Instruments as may be applicable:
RED 2014/53/EU; Low Voltage Directive 2014/3 5/EU; EMC Directive 2014/30/EU; Ecodesign Directive 2009/125/EC; ROHS Directive 2011/65/EU. Compliance with these directives is assessed using applicable European Harmonised Standards.
Radio frequency bands and maximum power levels (setect products only)
RadioTechnology | Maximum Transmit Power EIRP (mw) |
WLAN/Bluetooth: 2.4 GHz WLAN: 5 GHz |
100 |
NFC: 13.56 MHz | 10 |
Non-specific Short Range Device: 2.4GHz |
10 |
Singapore wireless notice
Turn off any WWAN devices while you are onboard aircraft. The use of these devices onboard aécraf is illegal may be dangerous to the operation of the aircraft, and may disrupt the cellular network. Failure to observe this instruction may lead to suspension or denial of cellular services to the offender, or legal action, or both.
Users are reminded to restrict the use of radio equipment in fuel depots, chemical plants, and where blasting operations are in progress.
As with other mobile radio transmitting equipment, users are advised that for satisfactory operation of the equipment and for the safety of personnel, no part of the human body should be allowed to come to dose to the antennas during operation of the equipment.
This device has been designed to comply with applicable requirements for exposure to radio waves, based on scientific guidelines that include margins intended to assure the safety of all people. regardless of health and age. These radio wave exposure guidelines employ a unit of measurement known as. the specific absorption rate (SAR). Tests for SAR are conducted using standardized methods, with the phone transmitting at its highest certified power level in all used frequency bands. The SAR data information is based on CENELEC’s standards ENS0360 and ENS0361, which use the limit of 2 watts per kilogram, averaged over 10 grams of tissue.
Thailand WWAN wireless notice
This telecommunication equipment conforms to the requirements of NBTC.
Laser compliance
Some products may contain a laser that is classified as a Class 1 Laser Product in accordance with US FDA regulations and the IEC 60825-1.
Each laser product complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated June 24, 2007 or Laser Notice No. 56, dated May 8, 2019; and with IEC 60825-1:2007.
exposure.
To reduce the risk of exposure to hazardous radiation:
- Do not try to open the module enclosure. There are no user- serviceable components inside.
- Do not operate controls, make adjustments, or perform procedures to the laser device other than those specified here’s.
- Allow only HP Authorized service technicians to repax the unit.
Power card notice
If you were not provided with a power cord for the computer or for an external power accessory intended for use with the computer, you should purchase a power cord that is approved for use in your country or region.
The power cord must be rated for the product and for the voltage and current marked on the product’s electrical rating label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the Diameter of the wire must be a minimum of 0.75 mm?/18AWG, and the length of the cord must be between 1.0 m (3.2 ft) and 2m (6.56 ft). If you have questions about the type of power cord to use, contact your authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product.
Safety Notices
- Plug the AC adapter into an AC outlet that is easily accessible at all times.
- If the power cord has a 3-pin attachment head, plug the cord into a grounded (earthed) 3-pin outlet.
Headset and earphone volume level notice
For your own Safety, use headsets or earphones compliant with the headphone limits in EN 50332-2.
When the HP product includes a headset or earphones, the combination is in compliance to EN 50332-1.
Environmental notices
Disposal of waste equipment by users
Battery Section
HP encourages customers to recycle used electronic hardware, HP original print cartridges packaging, and rechargeable batteries.
For more information about recycling programs, refer to the HP website at http://www.hp.com/recycie.
For information about removing a user-replaceable battery, refer to the user guide included with the product.
Electronic hardware and battery recycling
HP encourages customers to recycle used electronic hardware, HP orignal print cartridges, and rechargeable batteries. For more information about recycling programs, see the HP website at http://www.hp.com/recycle.
EFICIENCIAL ENERGETICA
Cumple con la nom-29-ENER-2017
Chemical substances
HP is committed to providing our customers with information about the chemical substances in our products as needed to comply with legal requirements such as REACH (Regulation EC No1907/2006 of the European Parliament and the Council}. A chemical information report for this product can be found at http://www.hp.com/go/reach.
India restriction of hazardous substances (RoHS)
This product, as well as its related consumables and spares, complies with the reduction in hazardous substances provisions of the “India E-waste Rule 2016.” It does not contain lead, mercury, hexavalent chromium, polybrominated biphenyls, or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except where allowed pursuant to the exemptions set in Schedule 2 of the Rule.
Information for European Union Commission Regulation 1275/2008
To locate product power consumption data, including when the Product is in networked standby with all wired network ports connected and wireless devices connected, refer to section P14 “Additional information’ of the product IT ECO Declaration at http://www.hp.com/hpinfo/giobalcitizenship/environment/Productdata/itecodesktop-pc.html.
Where applicable, activate and deactivate a wireless network using the instructions included in the product user guide or the operating system. information is also available at http://www.hp.com/support.
© Copyright 2015-2020 HP Development Company, L.P.
Bluetooth is a trademark owned by its proprietor and used by HP Inc. under license. Java is a registered trademark of Oracle and/or its affiliates.
The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
Twelfth Edition: August 2020
First Edition: August 2015
PRINTER: Replace this box with Printed- In (Pl) Statement(s) as per spec.
NOTE: This box is simply a placeholder. P! Statement(s) do not have to fit inside the box but should be placed in this area.