Maytag MSD2756GEW 27 cu. ft. Side by Side Refrigerator User Guide

MAYTAG MSD2756GEW 27 cu. ft. Side by Side Refrigerator

TO DISPENSE WATER

  1. Press the Dispense Type arrows on the dispenser control panel until “Water” is selected.
  2. Press a sturdy glass against the water dispenser paddle or place the glass below the water dispenser and press the Water button. Hold the glass close to the water dispenser spout to ensure that the water dispenses into the glass.
  3. To stop dispensing, remove the glass from the dispenser paddle or release the Water button.

TO DISPENSE ICE

Ice dispenses from the ice maker storage bin in the freezer when the dispenser paddle is pressed. To turn off the ice maker, see the “Ice
Maker and Storage Bin” section in the Owner’s Manual. Before dispensing ice, select which type of ice you prefer by pressing the Dispense Type arrows. The display screen indicates which type of ice is selected.


For crushed ice, cubes are crushed before being dispensed. This may cause a slight delay when dispensing crushed ice. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed to cubed, a few ounces of crushed ice will be dispensed along with the first cubes.

  1. Make sure the desired type of ice is selected. To switch between cubed and crushed, press the Dispense Type arrows.
  2. To dispense ice, press a sturdy glass against the dispenser pad or press the Ice button. Hold the glass close to the ice guide to ensure that the ice dispenses into the glass.
    IMPORTANT: You do not need to apply a lot of pressure to the paddle in order to activate the ice dispenser. Pressing hard will not make the ice dispense faster or in greater quantities.
  3. Remove the glass from the dispenser paddle to stop dispensing or release the Ice button.
    NOTE: Ice may continue to dispense for several seconds after removing the glass from the lever. The dispenser may continue to make noise for a few seconds after dispensing.

Pizza Pocket Assembly

Assembly Instructions

  1. Insert three hooks on part “A” into their corresponding slots on part “B”. Ensure the hooks fit into the side opposite to the upper lip.
  2. Assemble parts A and B at angle 90°.
    NOTE: Do not exceed angle more than 90°.
  3. Place the assembly onto the studs on the liner wall.

Application Overview