Panasonic 932AF2201 Wireless Charger for Mobile Phone User Manual

Wireless charger user’s manual

A portable device can be charged by just placing “qi” standard wireless charge compatible portable devices according to the Wireless Power Consortium, such as portable phones, smart phones, etc., on the charge area. This function can not be used with portable devices that are larger than the charging area. Also, depending on the portable device, it may not operate as normal. Please read the operation manual for portable devices to be used.

• The “qi” symbol
  The “qi” symbol is a trademark of the Wireless Power Consortium.
  
• Name for all parts

1. Power supply switch
2. Operation indicator light
3. Charge area

• Using the wireless charger Press the supply switch (1) of the wireless charger. Each press the power supply switch (1) it on/off. When turned the hybrid system off, the state of the power supply for wireless charger is memorized. Place the charging side of the portable device (etc. mobile phone) down. When charging, the operation indicator light (2) (orange) comes on. If charging is not occurring, try placing the portable device as close to the center of the charging area as possible. When charging is complete, the operation indicator light (2) (green) comes on.

Recharging function

• When charging is compatible and after a fixed timed in the charge suspension state, charging restarts.
• When the portable device is moved, charging is stopped for a moment and then it restarts.

• Lighting conditions of operation indicator light

*Depending on the portable device, there are cases where the operation Indicator light will continue being.

Since this device is always used with vehicle, it is not sold to general end users separately. Therefore there is no user manual of this device by alone. The following statements must be described on the user manual of the vehicle;

[For FCC]
This device complies with part 15 and part 18 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC CAUTION:

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a wireless power charger, pursuant to part 18 of the FCC Rules. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio communications, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.

The contact information for maintenance is described in the car manual by the manufacturer of the car in which this wireless charger is installed.

[For ISED]
IC: 216J-AF2201

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
   This equipment should be operated keeping at least 10cm or more away from person’s body.